I have:

Two 4 channel axle shafts- SOLD

Three 3 channel axle shafts- SOLD

One reluctor ring- SOLD

Five lugs- $10 plus shipping

 

To The Top

 

...........

 

Hey how hard is it to install an axle on the driveway of my house ??

Does it require anything special ??

 

It's pretty easy. Just takes basic hand tools. It depends on what carrier you have as to what exactly you have to do. With the Torsen carrier, you just remove a small bolt and remove the block in between the two axles. This will allow you to push the axles in far enough (once the wheel, caliper, rotor, and possibly the speed sensor are removed from each side) to remove the C-clips on the end of the axle (preferably with a magnet). Then the axle can be slid out.

The first time I did it, it only took about an hour from start to finish (still have to clean the cover and seal it, and fill it with gear lube), I could probably do it in about half the time now.

 

Yep, not difficult to do.

Bump for a good seller.

 

Thanks Pete

 

To The Top

 

Ttt...

 

Ttt....

 

Your PM Box is full!
One reluctor ring- $20 plus shipping
Ill take it!
Drop me a PM!

 

I apologize...didn't realize it was full. Yes...$20 shipped for a single reluctor ring and it's yours. PM sent

 

Reluctor ring SOLD

 

Ttt...

 

Ttt...

 

how much for shipping of one (with reluctor ring) to NY 11961? And how does the bearing surface look on it?

 

Shipping is $15. The bearing surface looks fine. They were removed from a working rear with good bearings. The carrier started making noise. I got a deal on a different complete rear, so I no longer need the parts.

 

Ttt...

 

PM coming

 

One 4 channel axle shaft SOLD