Bmr k-member and arms non adjustable in hugger orange. $750.00 SOLD

Billingsley fab 9 inch housing narrowed 3'' per side,strange alum center section,4.86 pro gear,40 spline gun drilled axles,wheelie bar brackets,Billingsley anti-roll bar,all powder coated black. Complete. $3300.00 SOLD

Jim evans 1050 cfm alcohol dominator brand new $1100.00 SOLD

Hvh adapter from 750 cfm to 1050 cfm carb for intake brand new $150.00 SOLD

Carbed ls1 intake brand new $275.00 SOLD

Msd box 6010 for carbed intake brand new just got back from msd because I thought it was bad ,but it ended up being my crank not firing this box $275.00 SOLD

Cam ls1 224/236 @.050 702 int lift 660 exh lift on a 119 lsa brand new in box $275.00 SOLD

Used set of 241 heads complete $200.00 SOLD

M/t slicks 28x10.50x15 S they have 50 passes these look brand new tons of life left $200.00 SOLD

M/t front runners 26x4.5x15 they have 50 passes these look brand new tons of life left $150.00 SOLD

Billingsley lower rear control arms adjustable powder coated black $150.00 SOLD.

Aerosapce vacum pump with all lines,brackets, and correct custom made mandrel to bolt right up to an ls1 with an asp pulley 50 passes $700.00 SOLD

Chrome moly wheelie bars fo r an f-body $500.00 SOLD.

All of my stuff is very well taken care of and in brand new looking shape my cars are immaculate go to our website and check out my car if any questions.

paypal accepted just add the 3% fee
Thanks Tim

 

How streetable is the cam, I seen it has a 119 lsa so it should be ok. Is the lift too much for stock pistons with out etching them?

 

This cam should fit easy in a stock motor,but I would always check just to be safe. It should be very streetable.

 

up for monday

 

Woaaaaah, did you just say that 700+ lift cam will work on a stock low end....

 

should clear fine the duration is very small and its on a 119 lsa. I would always check ptv clearances to be sure.

 

Poly/Poly? With hardware? If so stock size bolts?

Accept Paypal?

 

These are the chromemoly bars with adjustable rod ends they are solid no poly. Stock size bolts will work and I do have paypal ,but any paypal must add the 3% fee.

 

Lca's sold to sscam68

Intake and msd box is sold

 

how many miles on the heads and are they stock or have they been ported...pm me with the details...thanks

Rob M.

 

pm'd ya let me know

 

You stated that you are going back to stock, you wouldn't be interested in selling that VFN hood would you? I e-mailed a few months ago trying to find out what manufacturer produced that hood.

 

PM sent

 

hood is already sold. The car is not going back to stock just gonna race in stock

 

will consider trade on 9 inch for 12 bolt

 

vacum pump sold

 

lots of good parts left

 

Start making some offers on this stuff

 

Wheelie bars are sold

 

tttt for a good seller