stock 400 limit

Reply Subscribe

Thread Tools

Search this Thread

Apr 24, 2011 | 10:55 PM

john-dickjr

Thread Starter

Teching In

iTrader: (2)

Joined: Sep 2009

Posts: 28

Likes: 0

stock 400 limit

what is the rpm limit of a stock 400 crank ? my motor will be close to 14-1 compression ..solid roller cam..brodix heads..in my mustang with 4.56 gears and either 28-29 inch tire

Apr 25, 2011 | 06:30 AM

indyboom

Banned

iTrader: (11)

Joined: Mar 2006

Posts: 259

Likes: 0

From: YOUR MOMS

5500 safely. I have heard of some people going 6000K but i dont think its wise. Get a scat steel for 200 and make sure you balance it good

Apr 29, 2011 | 07:00 AM

87chev4x4

Staging Lane

Joined: Nov 2008

Posts: 57

Likes: 0

Yea stock 400 cranks don't like much over 5500 even with a balance job.... with all the affordable aftermarket stuff out there and with the quality of the rest of the parts I wouldn't skimp on the crank

May 11, 2011 | 07:34 PM

blk95formula

On The Tree

Joined: Oct 2008

Posts: 109

Likes: 0

From: wausau wi

^^^ Agreed wouldnt push much more than 5500

Aug 21, 2011 | 08:14 PM

64nova_wagon

Banned

iTrader: (1)

Joined: Aug 2011

Posts: 71

Likes: 0

I eneded up going with a eagle crank, its internal balance.. Nice stuff.. I built a 406

Aug 22, 2011 | 06:08 AM

pancherj

Launching!

Joined: Oct 2006

Posts: 289

Likes: 0

I had Andy Jensen build me an el-cheapo 406 when I was in high school. I routinly ****** at 6500RPM. Andy was appalled. He thought I should gear it up and shift at +7000RPM with the solid cam I had in there. This was with stock crank, rods and old TRW pistons. I think I would trust the stock, nodular crank to 6500 without thinking twice about it (assuming the machining work is good and it is balanced).

Aug 22, 2011 | 08:26 PM

1997bird

TECH Fanatic

iTrader: (2)

Joined: Nov 2006

Posts: 1,360

Likes: 0

From: Aztec, NM

The stock crank can handle about 6800 rpm regularly if it has been prepped correctly when it is re-ground, but you also need to change the clearances on the main jouranals at the same time. The stock crank will flex much more than a steel crank. I have taked a 3.5" SBC 400 main Scat Cast Steel lightweight crank well past it's recommended rpm limits in a budget dirt circle track car that was seeing 8,000-8,200 rpm regularly on a tacky clay track (it would pull your shoes off at the end of the night if you walked accross the surface). It is not a good idea to try this without having a very good balance job from an experanced shop, my friend that did the work has built IRL Indy car race engines, NHRA Top Fuel Alcohol Dragster, NHRA Funny Car, Trans Am race series engine's for Chyrsler's R&D team, and many more that I don't know about.