heads
#1
Staging Lane
Thread Starter
Join Date: Nov 2007
Location: Mass
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
heads
Hi could ne one help me out nd let me kno if this kit, http://store.summitracing.com/partde...=1#Application would fit wit these heads, http://cgi.ebay.com/ebaymotors/Small...QQcmdZViewItem...I have a gen 1 350 block out of a 95 suburban ...i was lookin for a roller cam and lifter set but im on a budget, couldnt find ne for a good enough price..so now im lookin for a hydraulic cam nd lifter kit like the one in the link...any suggestions??
Jeff
Jeff
#3
Staging Lane
Thread Starter
Join Date: Nov 2007
Location: Mass
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
thankns for that article, do u have ne suggestions as too wut a good set of heads with an assembled valvetrain in that price range might be...? Also, do u kno if the kit in the summit link would fit them...? Thanks
#4
11 Second Club
iTrader: (10)
Join Date: Jan 2008
Location: Orlando, fL
Posts: 343
Likes: 0
Received 0 Likes
on
0 Posts
IMO Dart's are going to be the best bang for your buck that's what i ran on my 71. You can get iron ones for the same price as those on ebay and aluminum will cost you about a grand. And any kit like that will fit as long as its for a Gen I SBC (non LTx or LSx).
#6
11 Second Club
iTrader: (10)
Join Date: Jan 2008
Location: Orlando, fL
Posts: 343
Likes: 0
Received 0 Likes
on
0 Posts
from where their website?
J/K, but seriously everyone I know that has had them thought they were nothing to brag about and wish they had spent a little more. They are obviously a lot better than stock but there are so many more to chose from for just a little more green. IMO your better off getting some better flowing iron heads for the same price when it comes to SBCs or spending a little more....
J/K, but seriously everyone I know that has had them thought they were nothing to brag about and wish they had spent a little more. They are obviously a lot better than stock but there are so many more to chose from for just a little more green. IMO your better off getting some better flowing iron heads for the same price when it comes to SBCs or spending a little more....