MTI Clear Lid GP
#41
TECH Resident
iTrader: (5)
Join Date: Nov 2001
Location: around
Posts: 885
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by BLK02TA
Is anyone else having problems with theres? Mine will not stay on. Its hard as hell to get on period and once the engine starts or shakes the littlest bit the clamps pop. I do not have this problem with my current lid (not factory). Also is it supposed to come without a hole for the AIT sensor?
argggg
argggg
#42
Launching!
Thread Starter
iTrader: (3)
Join Date: Jan 2007
Location: Houston, TX
Posts: 200
Likes: 0
Received 0 Likes
on
0 Posts
I test fit three different ones, including one which was sent back for fitment issues and they went on fine. It is a tight fit which is what it was made for and its not going to fit easily like the stock one does. All three that I test fit made a good seal and all the tabs lined up and the clamps went on fine.
Zach
Zach
#56
TECH Fanatic
iTrader: (11)
Join Date: Feb 2006
Location: Fort Knox, KY
Posts: 1,123
Likes: 0
Received 0 Likes
on
0 Posts
Got my clear lid on today Just wanted to clear up any fitment issues from my previous posts. Just had to push it on all the way. What was happening was the part where the maf goes in was pushing slightly on the bottom. Now thats its on all the way this thing is on there tighter than the previous lid and the factory junk. I LOVE IT!
Thanks again zach!!!
Thanks again zach!!!