BMR Drive Shaft Loop Installation Problem
12-13-2003, 03:37 PM
#1
12 Second Club
Thread Starter
iTrader: (6)
Join Date: Sep 2003
Location: Burbank, CA
Posts: 793
Likes: 0
Received 0 Likes
on
0 Posts
BMR Drive Shaft Loop Installation Problem Just got a BMR drive shaft loop but i'm having problems fitting it in. I currently have stock exhaust and stock Y pipe. I have pushed the loop as far as i can to the driver side of the car and it it only about 1/8 of an inch away from the Y collector. The exhaust is banging on the loop. If there is anyone out there that has installed one, any help or suggestions are very much appreciated. Thank you in advance.
12-13-2003, 06:43 PM
#2
TECH Fanatic
Join Date: Nov 2001
Location: Mi./Al.
Posts: 1,757
Likes: 0
Received 0 Likes
on
0 Posts
Loops seem to be a hit or miss when it comes to fitting correctly, I would send it back if you can. I tried a SLP loop on my stock y-pipe and had to remove it because it would touch the y-pipe, installed it on a friends SS which has a SLP y-pipe and it fit perfect.
Al
Al