Bent tubular k-member?
04-28-2012, 02:46 PM
#1
On The Tree
Thread Starter
iTrader: (9)
Join Date: Dec 2010
Location: ohio
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
Bent tubular k-member? I have a PAracing tubular k-member that is bent/tweeked the bolt holes don't line up by about half an inch to and inch. is there anywhere that can straighten it out or can i get the holes to line up and not have any alignment issues?
04-28-2012, 02:58 PM
#2
On The Tree
iTrader: (3)
Join Date: Jan 2010
Location: Louisiana
Posts: 125
Likes: 0
Received 0 Likes
on
0 Posts
Have to talked to PAracing? I wouldnt just go heating it up and bending it to fit. PA could maybe put it in the jig, find the bent section and try to replace the bent tube?
