ironmikektm525

Thinking of lowering my t/a 1.25. Question is my cat back(loud mouth 2) exhaust is a little tight where it goes over rear end(axle) If I lower it does that affect clearance in that area? Just don't want exhaust getting pinched or rubbing.thx

Spartan7

iTrader: (7)

That really depends on how well you routed it when you initially clamped everything together. That said, my LM1 (now a Dynomouth) is pretty tweaked from years on the car and me initially screwing up a little, but cleared just fine with BMR springs. Just watch out for driveways, the resonator will scrape sometimes.

meeklay812

iTrader: (6)

BMR Springs with LMII here, and there is about an inch clearance between the pipe and the rear end. The catback is very tight on there though, and never hits.

ironmikektm525

Great feedback!!! Thx guys!