BMR Motor Mounts
02-21-2006, 10:44 PM
#1
12 Second Club
Thread Starter
iTrader: (2)
Join Date: Jan 2004
Location: Palos Hills, IL
Posts: 3,321
Likes: 0
Received 0 Likes
on
0 Posts
BMR Motor Mounts Well I have orderd them NowI need to install them. Problem is the motor is completely together and the trans is mounted, i had not realize dhow bad they were untill the motor was mounted completely and assembled.
How should i install these? I have a basic hoist, a 2-3 jacks and a 4 ramps...
Let me know how to go aobut this, thanks guys Need to know ASAP
Also does this set the engine @ the same expanded height or does it lower or raise the motor? I am running straight headers w/ extensions and the drivers side extension already hits the floor board.
Need to know ASAP thanks everyone let me know please step buy step what to do, what to disconnect etc.
Adam
How should i install these? I have a basic hoist, a 2-3 jacks and a 4 ramps...
Let me know how to go aobut this, thanks guys Need to know ASAP
Also does this set the engine @ the same expanded height or does it lower or raise the motor? I am running straight headers w/ extensions and the drivers side extension already hits the floor board.
Need to know ASAP thanks everyone let me know please step buy step what to do, what to disconnect etc.
Adam
02-23-2006, 10:16 PM
#5
12 Second Club
Thread Starter
iTrader: (2)
Join Date: Jan 2004
Location: Palos Hills, IL
Posts: 3,321
Likes: 0
Received 0 Likes
on
0 Posts
should i remove the headers? what about the plastic piece of the windshield? How should i go about drilling the holes that are necessary?
