SVC707

iTrader: (33)

im in the process of installing my delete kit from sjm.. and i would like to know any tips on removing all the wires too.. ive already removed the wires from the fuse blocks, by removing from the pins. but how about the wires that go along the frame. are people just cutting then pulling them out or what. i dont want to cut any wires that may be needed besides just for abs. anything to be removed under dash? i want it to look "clean". all i have is a short block sitting in the bay right now so ive got room and want to do it before the motor goes in.

SVC707

iTrader: (33)

T T T

SJM Manufacturing Inc

iTrader: (5)

Open up the looms, remove anything binding the wire together i.e. electrical tape o r clips...Just follow the wires.

SVC707

iTrader: (33)

but what about when i get to the harness at the firewall? does it unplug or cut it there.

Meen95z

iTrader: (26)

I want some info on where to get this kit. I need one bad. Can anyone give me a link or info thanks!!!

SVC707

iTrader: (33)

click in the sig of sjm

GM Muscle

iTrader: (9)

The grommet on the fire wall has all the wires hot glued togethor. I found it to be too much of a pain to chase them to the other side without having wire diagrams. So I would suggest clipping them at the firewall.

John_D.

iTrader: (2)

You can chase some of them to the other side because the colors are unique. But some are the same (for example there are 4 red wires that all go through at about the same spot and you can't tell which one is which on the other side...).

SVC707

iTrader: (33)

https://ls1tech.com/forums/generation-iii-external-engine/502809-removed-air-pump-c-abs.html

i got this thread going now.. more in detail as to waht part i have questions on.... when i get to them instead of being vague..

Thanks for your help folks
Steve

SVC707

iTrader: (33)

t t t

DONAIMIAN

iTrader: (18)

Might want to check into a porportioning valve while youre at it.

SVC707

iTrader: (33)

in the link youll see a picture.. where i have the valve installed

DONAIMIAN

iTrader: (18)

whoops, looked right over it.