Strano Front Sway Bar Install
08-05-2006, 07:40 AM
#1
Launching!
Thread Starter
iTrader: (7)
Join Date: Jul 2005
Location: Pittsboro,NC
Posts: 202
Likes: 0
Received 0 Likes
on
0 Posts
Strano Front Sway Bar Install Is it possible to install this upside down? Does the bend under the underdrive pulley go towards the ground? My end links are at a very steep angle. I know this should seem obvious but it is not. Thanks in advance
08-05-2006, 09:58 AM
#2
TECH Junkie
iTrader: (10)
Join Date: Jan 2004
Location: Pearland, TX
Posts: 3,779
Likes: 0
Received 0 Likes
on
0 Posts
It's possible. I've seen a few pictures where people have the rear bars on upside down and it hits the rear differential cover. Can you post up some pics?
-Mike
-Mike
08-05-2006, 01:38 PM
#5
Launching!
Thread Starter
iTrader: (7)
Join Date: Jul 2005
Location: Pittsboro,NC
Posts: 202
Likes: 0
Received 0 Likes
on
0 Posts
Since it raised some questions I guess it was'nt a stupid question after all. I must have gotten them right because the cars handles great. The body roll seams to be greatly reduced and the ride is fine. I added 2-sweeps to the front shocks after reading a few post from other folks. It will take some time to get it right but thats what its all about right. 
08-05-2006, 02:26 PM
#6
TECH Addict
iTrader: (3)
Join Date: Nov 2005
Location: Lincoln, NE
Posts: 2,869
Likes: 0
Received 0 Likes
on
0 Posts
I would think it would go on the same way the stock one came off. With that in mind, I don't see how one could put it on upside down unless they weren't paying attention.
