HELP - Front Sway Bar End Link Won't Come Out
#1
TECH Apprentice
Thread Starter
iTrader: (7)
Join Date: Sep 2004
Location: Louisville, KY
Posts: 368
Likes: 0
Received 0 Likes
on
0 Posts
HELP - Front Sway Bar End Link Won't Come Out
I'm preping my car for the track tomorrow and I want to take out one end link on the front sway bar. I've got the nut off the top but the bolt won't fall through the hole. Its like the bolt is clipped into the washer and the whole assembly is at such an angle that it can't get past the opening in the axle. Do I need to have the car in some wierd position or something to get it lined up? I thought this was supposed to be easy. What am I doing wrong?
Last edited by 105; 07-12-2007 at 10:21 PM.
#3
TECH Fanatic
iTrader: (9)
Join Date: Dec 2004
Location: Schaumburg, IL
Posts: 1,693
Likes: 0
Received 0 Likes
on
0 Posts
Take the load off that corner and off the sway bar by putting the jack under the control arm and compressing the suspension. that will change the angle and allow the bolt to come out. At least thats what it sounds like is happening.
#4
TECH Apprentice
Thread Starter
iTrader: (7)
Join Date: Sep 2004
Location: Louisville, KY
Posts: 368
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by sixvi6-camaro
Take the load off that corner and off the sway bar by putting the jack under the control arm and compressing the suspension. that will change the angle and allow the bolt to come out. At least thats what it sounds like is happening.
Are the sway bar setups different certain on 98-02 camaro's? Otherwise I would think everyone would have this problem.
#6
TECH Apprentice
Thread Starter
iTrader: (7)
Join Date: Sep 2004
Location: Louisville, KY
Posts: 368
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Blakbird24
Did you try tapping it out with a hammer? I ended up breaking mine while trying to get them out for spring/shock replacement.