Shock bolt under master cylinder? help am i using wrong tool??
#1
12 Second Club
Thread Starter
iTrader: (10)
Join Date: Aug 2006
Location: NW Indiana
Posts: 719
Likes: 0
Received 0 Likes
on
0 Posts
Shock bolt under master cylinder? help am i using wrong tool??
i was reaading on ls1howto.com how to do front shock change. well i looesend up the brake master cylinder and i dont see anyway of getting that torques bit in there.
i dont know if theres another tool but i'm using the 3/8s drive socket type torqes bit. is there another tool? i cant get it to fit in there
thanks guys.
i dont know if theres another tool but i'm using the 3/8s drive socket type torqes bit. is there another tool? i cant get it to fit in there
thanks guys.
#2
TECH Senior Member
iTrader: (4)
Once you pull the nuts off of the master cylinder, you have to pull the master cylinder out and tilt it off of the studs on the brake booster. Then you should be able to get it loose with a 3/8 ratchet and a torx bit. That's how I've always done them.
Don't yank on it, just pull enough to tilt it out of the way.
Good luck!
Don't yank on it, just pull enough to tilt it out of the way.
Good luck!