UMI Kmember and Arms Install guide
08-24-2007, 01:04 AM
#21
10 Second Club
Thread Starter
iTrader: (17)
Join Date: Apr 2004
Location: Alloway,NJ
Posts: 2,409
Likes: 0
Received 0 Likes
on
0 Posts
ahhh ok..... ill check tommorrow.
i did notice that after the install on the driver side it is about the same clearance, ill check the pass side tommorrow.
i did notice that after the install on the driver side it is about the same clearance, ill check the pass side tommorrow.
10-31-2007, 11:34 PM
#22
Launching!
Join Date: Jul 2005
Location: Bay Area CA
Posts: 278
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the write up. I got quoted at $800 for the install and after seeing this thread decided I could do it myself.
About halfway through, k member and mounts off, just waiting till tomorrow to install the poly mounts. A/C unit is a snap to take out, only 6 or so bolts, and you can hang it off the engine with some coat hangers.
I did run into a snag with the steering rack. I notice I could pull it out of the stock k member with the way it was designed. I pulled off the return and feed line and unbolted the steering column thingy and took the k down with the rack still installed. Came out easy after that.
About halfway through, k member and mounts off, just waiting till tomorrow to install the poly mounts. A/C unit is a snap to take out, only 6 or so bolts, and you can hang it off the engine with some coat hangers.
I did run into a snag with the steering rack. I notice I could pull it out of the stock k member with the way it was designed. I pulled off the return and feed line and unbolted the steering column thingy and took the k down with the rack still installed. Came out easy after that.
