FS: 4 point roll bar - $$CHEAP$$
12-06-2009, 06:30 AM
#1
FS: 4 point roll bar - $$CHEAP$$ We recently cut a 6 point cage out of a 99 Z28 T2 car. T2 means it had to run a full interior.
The 4 point roll bar and rear down stays are in tact. Clean up the front half attachment points, weld on some floor plates, drill a few holes and you have and instant bolt-in cage.
Made from .120 wall DOM mild steel tube. Needs to be cleaned up and repainted. Located in Granbury, SW of Ft. Worth.
$100
Edit:
One of my pet peaves are for sale posts without a location.
The 4 point roll bar and rear down stays are in tact. Clean up the front half attachment points, weld on some floor plates, drill a few holes and you have and instant bolt-in cage.
Made from .120 wall DOM mild steel tube. Needs to be cleaned up and repainted. Located in Granbury, SW of Ft. Worth.
$100
Edit:
One of my pet peaves are for sale posts without a location.
Last edited by mitchntx; 12-06-2009 at 11:28 AM. Reason: Because I went brain dead.
