Do you have any ta drivers headlight assembly I know it's probably a long shot

 

do those steel drive shafts for 25 hold any more power than the stock aluminum unit?

if so, about how much

thank you

 

Any of them able to be finished? If so how much to have them finished?

 

any lifters and/or lifter trays
AC brackets ( F-body )
Alternator Brackets ( F-body )

are the parts at this location now? if so I might be stopping by tomorrow pending the cash left over from other purchases.

457 W. Hufsmith Tomball,TX 77375?

PMed tho you'll be traveling to the north side.

 

They are the factory steel driveshafts.. Im not sure on power but I had a customer come in before with a nitrous car using factory steel shaft, but had a stronger U-joint and it was spin balanced at Northwest drivetrain for higher speeds. I have seen some stock steel drive shafts vibrate harsh above 120 but his car trapped 130+ with no problems after the rebalancing.

 

I throw used lifters and lifter trays in the thrash.
I think I saw an AC bracket ill have to look later tonight.
All used parts are in the building at my house in storage.

 

pm sent

 

stock LS1 4L60E flexplate?

 

have any lt1 manifolds??

 

Yes I do.. make me an offer worth me pulling it off a car lol

 

No sir I sure dont

 

I need a starter& alternator with the bolts, for a truck engine, 5.3 1999-2000

 

[QUOTE=TehGODofGreen;14289464]any lifters and/or lifter trays
AC brackets ( F-body )
Alternator Brackets ( F-body )

QUOTE]

I did find an a/c bracket with the tensioner on it. Not sure what the going rate is for this bracket.

 

I "think" I have a starter.. Im sure its from an fbody but im not sure if there is a difference.