ok guys... i have a lot of things for sale here... i'm parting out my blue truck and i have a 408 sitting in my garage i was going to rebuild but other priorities have come up and i'm selling it for my friend....

the 408 has been taken apart and only the crank has been inspected and is GOOD...motor had about 18K miles on it when we pulled it...

here's all of what i've got out right now...

LQ9 block bored .030 $600 obo... NO SHIPPING... LOCAL ONLY OR MEET UP...

block needs to be cleaned.... new cam and main bearings... cylinders need to be honed as well... comes with rear and valley covers... NO SENSORS...













Eagle 4" crank... HAS BEEN CHECK AND POLISHED... WILL TAKE STANDARD BEARINGS... $475 OBO... NO SHIPPING... LOCAL OR MEET UP ONLY... I CAN GET MORE PICS OF THE CRANK IF NEEDED... JUST DIDN'T WANT TO TAKE OUT OF THE BAG... <<< SOLD



Dished pistons (for 4.030" bore) with Eagle rods H-beams (6.125")... i don't know what pistons are on the rods... my guess Wiseco or Diamond pistons... has a part number of 6396A3 on the top... i have not had much time to research or call around to get the cc of the pistons... i've only cleaned up two of the pistons... ALL NEED NEW BEARINGS AND RINGS... the skirts could use some touching up as well... asking $475 obo + shipping...<<< SOLD









things off of my truck i have for sale...

Comp LSr 219/227 .607/.614 112 lsa with TSP pushrods $300 + shipping... still in truck right now but will be taken out this weekend... has about 9k miles on cam and pushrods...

LS1 fans and Nelson harness...$150+shipping... still on truck as well but will be taken off this weekend or when purchased... have had on the truck for over two years with no problems... << SOLD

Stock intake manifold with fuel rails and injectors... $100 obo + shipping...

Dynomax Bullet catback with cutout full 3"... for single cab shortbed trucks only... $100 obo... LOCAL ONLY...

there will be more as i start tearing it all apart... headers, y-pipe and transmission are already SOLD...so please don't ask about those...

any other questions just PM me...

 

Bump....

 

Got pics of the rest of the exhaust?

 

I just pulled it off today. I can get you some tomorrow

 

if you can get me the comp ratio and compression distance on the pistons and rods I might be able to get them off your hands.

 

I don't have any compression ratio numbers but the rod length is 6.125

 

Bump...

 

fans and harness sold...

 

pm sent

 

Rotating assy is sold

 

Bump..

 

bump...

 

Bump...