TNT Crandall (Dallas Raceway) Call Outs 01/08/11
#262
Thats the plan.
------------------------------------------
Oh another video of the 10.85 pass
I just got the video from the car I raced . Very nice guy to send me the video.
Here's his view of my pass..
http://www.youtube.com/watch?v=KkM4KAOYT1U
------------------------------------------
Oh another video of the 10.85 pass
I just got the video from the car I raced . Very nice guy to send me the video.
Here's his view of my pass..
http://www.youtube.com/watch?v=KkM4KAOYT1U
#263
#264
Bully lol
I got your race after him lol Just spot me 3 cars and the Jump lol hahah
Same race just from my camara and the time slip is below
http://www.youtube.com/watch?v=c6XGA3sGdrc
Same here only way a lot of us could run him lol
I would just go with the 150 or 175 if I couldn't do it with that... I would just say **** it lol
I got your race after him lol Just spot me 3 cars and the Jump lol hahah
Same race just from my camara and the time slip is below
http://www.youtube.com/watch?v=c6XGA3sGdrc
I would just go with the 150 or 175 if I couldn't do it with that... I would just say **** it lol
#265
**** I may not be able to get past the 60 foot if it's anything like last time. I took the day off today to put my axle back in. Just gotta get over being lazy. If I get it done I'll go to the track tomorrow to check everything over.
#268
#270
#271
#272
Yeah I used his tires. I was actually feeling better that my car back down to where it should be. I was worried after I tried swapping the converters again. 10.17@131.97 was my best yesterday. I looked up the DA and found that it was 404. So not too bad considering my 10.02 was -565 DA. I have to figure out my tire situation. Seems like the drag radials are at their limit in the cold weather. I think new drag radials would probably be ok. But as much as I'm afraid slicks will slow me down I'll probably try them at this point. If I can stop all spin and shave some weight from the tires I may see some results. I need a 1.34 or better 60 to see a 9.
I'll get new spark plugs and tune the car for having the intake filter off. And probably get slicks and go back on the 5th. Just have to hope for some awesome DA and sticky traction.
I'll get new spark plugs and tune the car for having the intake filter off. And probably get slicks and go back on the 5th. Just have to hope for some awesome DA and sticky traction.
#273
We should have some vids put together for a thread soon.
#274
I was there with my lil Vette. Joshua (RMS-MAN on LS1) was putting the finishing touches on my newly installed built A6 from Century Trans and 3200 Yank converter. He drove/ tuned in like 10 passes. 1st pass was the slowest 10.13, then it went 9.98, 9.95, 9.93, 9.80, and a best of 9.75 at 139 mph. The right lane was hooking much better than the left.
We should have some vids put together for a thread soon.
We should have some vids put together for a thread soon.
#275
...makes for a nasty lil street car.
#276
#277
9 sec passes
I have a stock front wheel that I had widened by Weldcraft (now 11x18). I run a MT ET Street II in 305/35/18 full time. We had the tires at 22 psi on best results.
I almost forgot about the Pfadt adjustable shocks..we made tweaks on those too.
I almost forgot about the Pfadt adjustable shocks..we made tweaks on those too.
Last edited by silver bullet c6; 01-23-2011 at 05:40 PM. Reason: add slips