SPEEDYws6

iTrader: (9)

The car needs a new clutch. So I had all that in mind when I built it. I got spoiled with my TA because you didn't have to touch the exhaust to pull the Trans.

I'll see what I can do about a fly by video.

VinR1

iTrader: (17)

Very nice!

xX-Z28-Xx

iTrader: (4)

Flyby video!

jbridwelltransam

iTrader: (12)

back in for the fly by video lol

drago1217

iTrader: (6)

I'm in for fly by also. Looks good I have been considering this myself.

Xovit

This is a very impressive setup. I like it a lot, what series mufflers are those from Magnaflow? You said 6", whats the length on them if you know by chance? I too would love to see/hear a fly by vid too!

SPEEDYws6

iTrader: (9)

Still no drive by video. But I pulled the Trans out without removing the exhaust. I thought it was possible but couldn't be sure until I proved it.

CySevans

I did this to mine back in the day. But I had mine flanged so I could remove it. Sounded like a friggin' NASCAR, though. It needed more than bullet mufflers.

http://www.angelfire.com/on2/Vinnie/truedual.html

SPEEDYws6

iTrader: (9)

I'm pretty sure the mid pipe section will drop out in less than 15 min. At least it did before I did the final install and sucked the band clamps down tight. But if I don't have to test it I'm not going to.

ss4chad

iTrader: (26)

Looks great dude, I plan on doing close to the same thing with oval tubing, no H or X pipe, over the axle with twin Magnaflows out the back under the bumper slashed tips.

I'm looking for someone to do the work around the Dallas/Ft.Worth area. I wonder how much it would cost just for labor if I bought all of the parts?

Chad