Fastech ##s
Fastech ##s Have a question for anybody out there.. I have heard that alot of people say that fastech's dyno reads a little bit lower numbers then others in the area.. I am not complaining about my numbers. Sean did an outstanding tune and the car feels soooooo much better and responds much much better. Some ofthe people that I told my numbers to thought that they sounded a little bit low considering my first pull was 333rwhp with only SLP induction and lid, Mac mids and Y, flowmaster catback. I am still running the stock LS1 intake also so basically I was just curious to if anybody else has heard of this..
Thanks Again Sean, car handles awesome!!!
Thanks Again Sean, car handles awesome!!!
Last edited by frisky2101; Sep 26, 2005 at 07:32 PM.
my car put down 386/365 at fastech when sean tuned it.
I went over to RPM in lewisville where all my other dyno's have been done, just to get a comparison to see what gains i had from the cam/tune and put down 395/377.
Is your car an A4 or an M6?
I went over to RPM in lewisville where all my other dyno's have been done, just to get a comparison to see what gains i had from the cam/tune and put down 395/377.
Is your car an A4 or an M6?
Originally Posted by mellowyellow
I dynoed 376 at Fastech and 371 at Rpm the same day 1 1/2 HRs apart. Pretty close if you ask me. Car sat for 45 min before pull at Rpm too.
Daniel
Originally Posted by Daniel@SQR
Where they corrected the same? you can get about 10hp difference from switching the correction , STD, SAE, ect.. just something to look at.
Daniel
Daniel
Trending Topics
Originally Posted by mellowyellow
I dynoed 376 at Fastech and 371 at Rpm the same day 1 1/2 HRs apart. Pretty close if you ask me. Car sat for 45 min before pull at Rpm too.
But the only reason i went to Rpm was b/c all my other previous dyno's had been done there. So i wanted a comparison, soley for the purpose of seeing what i had gained from the cam.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Originally Posted by mellowyellow
Yes sir SAE. Sean sent me over there to see if it would Dyno any higher . It did'nt
Wasnt real happy with my Dyno #'s, but I talked to Sean about them.... He explained that if I was hung up on the numbers the way that many people are.... He could lean out my Engine and even put better than pump gas in it and get me a "Unrealistic Dyno Pull" in comparrison to the street.... but it would be bigger "Bragging" numbers.
I elected to just allow him to give it a good tune... and see what it pulls as is. I will tell you on the street I have run hard against anyone, and on a roll I pulled slightly on a S/C LS1 that "Dyno's" more then me.. at only 5PSI... If I threw the switch and allowed my psi to climb to 9.... it may have been worse.
I elected to just allow him to give it a good tune... and see what it pulls as is. I will tell you on the street I have run hard against anyone, and on a roll I pulled slightly on a S/C LS1 that "Dyno's" more then me.. at only 5PSI... If I threw the switch and allowed my psi to climb to 9.... it may have been worse.
Originally Posted by longrange4u
Wasnt real happy with my Dyno #'s, but I talked to Sean about them.... He explained that if I was hung up on the numbers the way that many people are.... He could lean out my Engine and even put better than pump gas in it and get me a "Unrealistic Dyno Pull" in comparrison to the street.... but it would be bigger "Bragging" numbers.
I elected to just allow him to give it a good tune... and see what it pulls as is. I will tell you on the street I have run hard against anyone, and on a roll I pulled slightly on a S/C LS1 that "Dyno's" more then me.. at only 5PSI... If I threw the switch and allowed my psi to climb to 9.... it may have been worse.
I elected to just allow him to give it a good tune... and see what it pulls as is. I will tell you on the street I have run hard against anyone, and on a roll I pulled slightly on a S/C LS1 that "Dyno's" more then me.. at only 5PSI... If I threw the switch and allowed my psi to climb to 9.... it may have been worse.
Originally Posted by longrange4u
Wasnt real happy with my Dyno #'s, but I talked to Sean about them.... He explained that if I was hung up on the numbers the way that many people are.... He could lean out my Engine and even put better than pump gas in it and get me a "Unrealistic Dyno Pull" in comparrison to the street.... but it would be bigger "Bragging" numbers.
I elected to just allow him to give it a good tune... and see what it pulls as is. I will tell you on the street I have run hard against anyone, and on a roll I pulled slightly on a S/C LS1 that "Dyno's" more then me.. at only 5PSI... If I threw the switch and allowed my psi to climb to 9.... it may have been worse.
I elected to just allow him to give it a good tune... and see what it pulls as is. I will tell you on the street I have run hard against anyone, and on a roll I pulled slightly on a S/C LS1 that "Dyno's" more then me.. at only 5PSI... If I threw the switch and allowed my psi to climb to 9.... it may have been worse.
Oh and to answer you question... from what I have seen, yea Fastech's dyno is a little low. But I would prefer to compare my 431RWHP to anyones leaned out and preloaded 475-500.... not to mention that I will have a T-67 soon too and Sean will have to tighten up my tune some.
Come with numbers that are not so impressive and run strong... rather then come with GREAT numbers and run like a B**ch! LOL
Come with numbers that are not so impressive and run strong... rather then come with GREAT numbers and run like a B**ch! LOL
TECH Fanatic
Joined: Mar 2002
Posts: 1,169
Likes: 0
You can't worry too much about dyno numbers. When you don't make alot of peak HP, you hope the area under the curve is good. That is really what makes a good street car.
Get it to the track and then decide. Sounds like you have the right stuff to launch with and really test it out.
Get it to the track and then decide. Sounds like you have the right stuff to launch with and really test it out.
