Help........tons of codes........
Thread Starter
Joined: Sep 2003
Posts: 813
Likes: 0
From: Harlingen, TX.
Help........tons of codes........ Well this is whats going on!! To make a long story short my damn car wont start. Its started off my missing alot then after a few days it just stopped turning on. It just cranks over and over!! I'v hand problems with the crank sensor before so I just assumed it was that. So I replaced it with a new one but it still does the same thing. I'v done a few searches and checked the main things.
1) fuel pump turns on and there's fuel @ the fuel rails
2) Ignition relay is good I'v swapped them around and they work fine
3) All the fuses are fine non of them blown
There's is NO spark at the plugs on either side and I have a ton of codes here's the list hopefully someone can help me out PLEASE!!!
P1637 - Generator L terminal circuit(been there before problem)
B1001 - Option Configuration Error
U1000 - Class 2 communication malfunction
U1300 - Class 2 short to ground
U1016 - Loss of class 2 communication with VCM
U1040 - Loss of class 2 communication with ABS
U1096 - Loss of communication with IPC
1) fuel pump turns on and there's fuel @ the fuel rails
2) Ignition relay is good I'v swapped them around and they work fine
3) All the fuses are fine non of them blown
There's is NO spark at the plugs on either side and I have a ton of codes here's the list hopefully someone can help me out PLEASE!!!
P1637 - Generator L terminal circuit(been there before problem)
B1001 - Option Configuration Error
U1000 - Class 2 communication malfunction
U1300 - Class 2 short to ground
U1016 - Loss of class 2 communication with VCM
U1040 - Loss of class 2 communication with ABS
U1096 - Loss of communication with IPC
Thread Starter
Joined: Sep 2003
Posts: 813
Likes: 0
From: Harlingen, TX.
I checked with a tester light to see if the coil packs had power and they were getting power. If the ground was bad do think they would still have power? I'll check it out tomm either way doesnt hurt!!
