Few questions about my 05 Camaro RS....
11-10-2007 | 09:27 AM
#22
Ratchet, how much for the (EMFACD) externally mounted forced air cooling device shipped to 09033? are you sure i will also need one of these? man this is gonna be a project and a half.
Also since you are a transmission specialist, do you have any of the aforementioned 21+ speed transmission's?
Also since you are a transmission specialist, do you have any of the aforementioned 21+ speed transmission's?
11-10-2007 | 09:29 AM
#23
TECH Apprentice
Joined: Feb 2003
Posts: 336
Likes: 0
From: houston
Madman Well I think that the sail panel and fuel tank mounting locations are all well and good... but, I would recommend that you put it somewhere in the external airstream because of the heat it will be generating at max power output. Not many folks realize that depending on the cycle rate those damned flux caps can exceed a 500*f threshold in mere seconds. And the last thing you want is to melt a speaker wire, pulling the factory Halon Fire Suppression trigger can get messy... not to mention expensive!
Now, if you insist on the aforementioned mouniting locations let me suggest an externally mounted forced air cooling device....
It could easily be mounted on the roof of the vehicle and might just keep the Flux Cap cool enough to prevent an unfortunate situation.
We have several coolers very similar to the one depicted in the photo in stock and provide custom installation as well. LMK if you are interested!
Just my .02
g
Now, if you insist on the aforementioned mouniting locations let me suggest an externally mounted forced air cooling device....
It could easily be mounted on the roof of the vehicle and might just keep the Flux Cap cool enough to prevent an unfortunate situation.
We have several coolers very similar to the one depicted in the photo in stock and provide custom installation as well. LMK if you are interested!
Just my .02
g
11-10-2007 | 09:41 AM
#24
AG,
Your going to need to either contact 13 Speed Inc or 21 Speed Inc depending on which tranny you intend to use on this project. I would personally go with the 21 Speed Inc package as more has got to be better!
Also, i think that large cooler mounted on the roof of your camaro might cause a little bit of drag so I would suggest a water cooler style trailer that you pull behind the car. Especially since the FC will be rear mounted the water wont have to travel as far.
Contact Madman for some Fab work of the 500 gallon trailer and intercooler!
Your going to need to either contact 13 Speed Inc or 21 Speed Inc depending on which tranny you intend to use on this project. I would personally go with the 21 Speed Inc package as more has got to be better!
Also, i think that large cooler mounted on the roof of your camaro might cause a little bit of drag so I would suggest a water cooler style trailer that you pull behind the car. Especially since the FC will be rear mounted the water wont have to travel as far.
Contact Madman for some Fab work of the 500 gallon trailer and intercooler!
11-10-2007 | 01:17 PM
#25
11-10-2007 | 04:00 PM
#26
Staging Lane
Joined: Feb 2007
Posts: 78
Likes: 0
From: sherman Tx
i just thought that my gf was bitching for no reason when she was saying she was geting blisters on her butt when we went racing jet fighters...but maybe i need to invest in one of the 500 gallan water coolers...but i dunno...maybe i could find a way to get a roof mounted cooler but i dunno were to mount it on my honda spree...any body have any idea..
Justin
Justin
11-10-2007 | 04:03 PM
#27
Staging Lane
Joined: Feb 2007
Posts: 78
Likes: 0
From: sherman Tx
http://www.sonicjay.com/spree/spree-tank-cast.jpg
this was before the 13 speed was installed i would not keep the front wheel on the ground....it was nuking futs.....my left leg was broken in a horific spree crash..but i took the packaging that the fc was shipped in and fashend a cast...
this was before the 13 speed was installed i would not keep the front wheel on the ground....it was nuking futs.....my left leg was broken in a horific spree crash..but i took the packaging that the fc was shipped in and fashend a cast...
11-10-2007 | 10:44 PM
#28
Sorry to hear about your accident, i believe i will be good to go in my 05 RS though. Anyone else have any ideas on how to mount the cooler?
Last edited by AGRV8D; 11-11-2007 at 02:19 AM.
11-11-2007 | 02:07 AM
#29
you guys are all newbs, everyone knows the reason the FC is mounted in the delorean is bc the extra pin on the pcm that attaches to the STOCK 8 SPEED transmission, you have to upgrade you're pcm, and if you go to 6 spd inc, package 14a-15c++ both have the two extra gears available, then thats the only upgrades you require
god damn it, i've never seen anyone so behind in my life, USE THE FREAKING SEARCH BUTTON
god damn it, i've never seen anyone so behind in my life, USE THE FREAKING SEARCH BUTTON
11-11-2007 | 02:03 PM
#31
you guys are all newbs, everyone knows the reason the FC is mounted in the delorean is bc the extra pin on the pcm that attaches to the STOCK 8 SPEED transmission, you have to upgrade you're pcm, and if you go to 6 spd inc, package 14a-15c++ both have the two extra gears available, then thats the only upgrades you require
god damn it, i've never seen anyone so behind in my life, USE THE FREAKING SEARCH BUTTON
god damn it, i've never seen anyone so behind in my life, USE THE FREAKING SEARCH BUTTON
BWAHHAHAHAAHAHAHAHAHA!!....nice James
11-11-2007 | 07:07 PM
#32
Staging Lane
Joined: Feb 2007
Posts: 78
Likes: 0
From: sherman Tx
i cant use the serach button, the laptop on my moped is only dial up, and somtimes i cant ride very far cuz the phone cord is only a 8 miles long cord and well i was goin for the world recod for the longest wheelie and well i made it 8 miles and 2 feet and the cord jerked outa my laptop and killed my FC and its back up FC ..so i didnt beat the record of 8 miles 2.5 feet...
but the wreck wasent bad..i was still motoing around with the cast
but the wreck wasent bad..i was still motoing around with the cast
11-12-2007 | 12:04 AM
#33
Does the ebay unit come with everything to get it working? I mean like wires, fuse box, power amplifier, gamma rays reluctor, electron activation software, and premium mounting hardware? I need to know ASAP! I need one!
11-12-2007 | 02:14 PM
#39
Be sure to monitor your temperature once the Flux Capacitor is installed. Don't let it go above 250F on the spread spectrum threshold. I suggest a custom tune with 6-12 pin extension for the pcm that supports additional wiring recomended for the capacitor as well.
