LS lift plate dimensions (template)
#1
Staging Lane
Thread Starter
iTrader: (1)
Join Date: Feb 2012
Location: Alexandria, Louisiana
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
LS lift plate dimensions (template)
would anyone with a valley mount lift plate be willing to get me some measurements on the valley plate width and length, and hole size and spacing. i don't have an engine yet, but have the materials to make one versus spending 50+ dollars on something i could build in about an hour. i only need the specs from the plate, not the lifting bar since i already have an engine load leveler.
#2
Teching In
I'll draw one up in cad for you aye..
Damn I'm a nice guy.
Iv been drawing up and making a few ls1 bits over the past few months as they are so expensive to get here in NZ!
Damn I'm a nice guy.
Iv been drawing up and making a few ls1 bits over the past few months as they are so expensive to get here in NZ!
#3
Teching In
All done.
I don't have time to test it but it should be right. Flick me a PM with your email address and I'll send the file through.
Its in good faith.. So don't start producing them to sell Lol.
I don't have time to test it but it should be right. Flick me a PM with your email address and I'll send the file through.
Its in good faith.. So don't start producing them to sell Lol.
#4
13 Second Truck Club
iTrader: (17)
Join Date: Aug 2008
Location: baton rouge
Posts: 637
Likes: 0
Received 0 Likes
on
0 Posts
I know this is an old thread and the op doesnt need the measurements but i wanted to put them out there for the next person. I started out with a piece of plate 1/4 in. Thick 6" x10" long. That covers 6 holes. The bolt spacing is 5 1/8" side to side by 4 3/8" front to back with the holes being 3/8" diameter.
#7
Teching In
Join Date: Jun 2016
Location: Georgetown OHIO
Posts: 14
Likes: 0
Received 0 Likes
on
0 Posts
Well I no this post is old , but I've been searching Google now for 3 hours and this is the only measurements I could find ! (My block is at the machine shop!) So I would like to thank 726.0chevelle for those measurements ! I hope thier right cuz tomorrow when I get to work I'm having my buddy fab me one up thx !