JPWS6

Has anyone seen or have the stainless steel tool box from sam's club? It is made by some off brand, steel tek i think, but I was pretty impressed with it. I was thinking of picking one up, the price is $650 and is bigger than I need, but it seems to be a lot better than anything I could buy at sears for that price. Any opinions from anyone who has seen it or has one?

VETTEX2

Sounds like the same one at Costco.
Seemed like a decent box.
I have MAC and Snap-On boxes now.
It compared favorably, especially for the price.

LS1NOVA

iTrader: (12)

Also check out Harbor Freight, if you have one around. They also have a decent box for around $450 or $650 with side cabinet.

cm02WS6

My dad has that box. It is made well and the drawer slides seem to be OK. They have a little more friction than my Craftsman ball bearing ones, and they move side to side more. The one complaint I have about the design of the box is that most of the drawers are too short to fit a variety of things. The drawers look taller than they really are. Putting an air drill or torque wrench box in them would probably rub a little or interfere enough so that they wouldn't shut.

2002WS6_MN6

There are two versions of that tool box..
The good one and the cheap one..

The good one is made by Hammerhead and the cheap one is not..

I went to Costco by me (NJ) about a year ago when I heard about them being sold for $650.. When I got there it wasn't the hammerhead box.. I don't remember what the other brand was but it's junk..