Beaudacious Back Half
#1
Beaudacious Back Half
Doing a little project in the shop
1965 Olds with a healthy big block
I'm putting a handmade sheet metal 9" housing with strange internals
Ladder bars with DA qa1 coil overs
Little bit of frame work to fit the 325/50/15 et street r tires
Should be done by the end of the month
Tires under just for mock up
1965 Olds with a healthy big block
I'm putting a handmade sheet metal 9" housing with strange internals
Ladder bars with DA qa1 coil overs
Little bit of frame work to fit the 325/50/15 et street r tires
Should be done by the end of the month
Tires under just for mock up
The following users liked this post:
G Atsma (01-14-2020)
The following users liked this post:
2ToeRacing (01-31-2021)
The following users liked this post:
2ToeRacing (01-31-2021)
#6
#7
TECH Senior Member
HAZ is new to my limited-welding self. Heat Affected Zone? How close am I?
Trending Topics
The following users liked this post:
G Atsma (01-14-2020)
The following users liked this post:
G Atsma (01-14-2020)
#12
Watt's linkage bracket
due to customers request to maintain rear seat, and the fact that this car makes roughly 1000hp on drag radials I have had a bit of a challenge putting all the suspension points where they need to go. This is solely the reason for the Watt's linkage, the other reason is that when they get the car back to their shop and on the hoist to inspect the work it should have them wondering
The following 2 users liked this post by orange88ls1s-dime:
dixiebandit69 (03-24-2020), G Atsma (02-07-2020)
#15
My biggest downfall as a human being :
im overzealous on my timeline to get any project finished
275 hours so far and only a small glimmer of hope for the finish line
#17
Thanks for the offer, stop in sometime
im always open to and tips and tricks for welding
No matter how long you have been doing something there's always something new to learn
im always open to and tips and tricks for welding
No matter how long you have been doing something there's always something new to learn
The following 2 users liked this post by orange88ls1s-dime:
01CamaroSSTx (03-19-2020), crewguy (01-02-2021)
The following users liked this post:
biketopia (01-28-2021)
#20
TECH Enthusiast
Looks sinister as hell, good work.... That should be negan's car in the walking dead..... I'm imagining a set ove 17x11 rear and 17x9.5 front billetspecialty polished/ black winlite wheels on it. But I day dream alot so thats my spurt ove the moment comment. Maybe I should drink less!!!
The following users liked this post:
orange88ls1s-dime (01-30-2021)