Welded Bung - air gap
#1
Welded Bung - air gap
Hi Folks
I welded a Bung onto my LTH for a wideband O2 sensor but I could not get to the top of the bung without dropping the LTH which I was not about to do. There is a small gap on the top of the bung. Is there anything available that I use to fill the gap - like epoxy, etc?
thanks
Bill
I welded a Bung onto my LTH for a wideband O2 sensor but I could not get to the top of the bung without dropping the LTH which I was not about to do. There is a small gap on the top of the bung. Is there anything available that I use to fill the gap - like epoxy, etc?
thanks
Bill