What to use to fabricate gas tank straps
12-29-2007, 08:17 PM
#1
Staging Lane
Thread Starter
iTrader: (8)
Join Date: Mar 2004
Location: SO CAL
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
What to use to fabricate gas tank straps I need to fabricate gas tank straps. Has anyone done this and what did they use and where did you get it from? Thanks
12-29-2007, 10:35 PM
#2
6 & 8 Second Club
Join Date: Aug 2006
Location: Illinois, RT 66 dragway area
Posts: 2,284
Likes: 0
Received 0 Likes
on
0 Posts
.
On my slow car I used aluminum flat stock from menards for the 5 gal cell.
On a truck that was in an accident, I used steel flat stock, had to get from the steel mill, because menards didn't have any long enough.
.
On my slow car I used aluminum flat stock from menards for the 5 gal cell.
On a truck that was in an accident, I used steel flat stock, had to get from the steel mill, because menards didn't have any long enough.
.
01-04-2008, 06:24 PM
#5
Staging Lane
iTrader: (2)
Join Date: Feb 2007
Location: SoCal
Posts: 67
Likes: 0
Received 0 Likes
on
0 Posts
Patton's metal supply
http://www.pattonscorp.com
has places all over SoCal. They sell scrap or left-overs from cuts as well...
I go to the one in Irwindale but there is one in Ontario as well as others depending on where you are from.
Ryph
http://www.pattonscorp.com
has places all over SoCal. They sell scrap or left-overs from cuts as well...
I go to the one in Irwindale but there is one in Ontario as well as others depending on where you are from.
Ryph
