2001 Red WS6
03-29-2010, 10:12 PM
#1
Staging Lane
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Sacramento, CA
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
2001 Red WS6 Year: 2001
Make: Pontiac
Model: Trans Am
Price: $22000
Mileage: 48000
Private or Dealer Listing: Private Listing
Location (State): CA
Color: Black
Transmission: Manual
Drivetrain: Rear Wheel Drive
LS Engine?: Car has LS engine
It has 402 shortblock built by Lme, TFS 235's, comp cam ( cam, lifters, pushrods, timing chain), Jesel Mohawk rockers, Meziere water pump, Fluid dampner, Moroso aluminum oil pan, Fast 92mm ported by Tony Mamo, Nick Williams throttle body, 42lbs injectors, Racetronix fuel pump and hot wire kit, 1 7/8 Kooks headers y pipe is 3 inlet 4inch outlet and a 4inch cutout, and exits into a BB exhaust. The T-56 was built by six speed inc Z06 gear ratios, spec 3 clutch, aluminum flywheel, 3.5 aluminum driveline, and a 12 bolt mosier with 4.10 gears. This car has every part UMI makes for it. I'm running C6 Z06 brakes on all four corners, with 18x11.5 and 18x9 wheels 315/35/18 in the back and 255/40/18 in the front. Koni adjustables, and a ground control coilovers. The paint was wet sanded and buffed and is in better condition that when it was new. The interior is also in great condition it is stock appearing with the aception of the momo steering wheel and shift light, I have done a ton of weight reduction, no heater, ac, airbags, rear seat belts, abs traction control, it weighs 3250 without me in it. It has a touring car look, and I wanted it to look like GM could have made it this way, no stickers graphics, fancy paint.
The car does have a salvage title it was hit in the rear, but it was very light damage and was repaired by a very reputiable body shop here in town I can take panels off to show you they're was no structual damage. I put new dealer tailights filler panel and bumper and the hatch back was also replaced with a new one because it had a crack in it. The car has a wolf engineering 6 point 4130 roll bar, it has been fully dyno mated. The rest of the interior is bone stock the interior is a 9 out of ten no rips or tears cracks of any sort the windows have 35% tint on the front and 5% in the rear, the reason i give it a 9 is because it does have the crack in the drivers side door panel. The car has a full polk audio system every speaker the car came with was replaced and a 10 inch sub was put in the rear corner and 2 amps run everything of the stock dash stero. The outside of the car is a 10 out of 10 it has no dents or scratches at all it has been garage kept since I bought it with 8300 miles. You really have to see it to believe how clean this car really is. This car was built up in a 4 year period it really has the best of the best. I am also willing to trade for a old muscle car camaros, chevelles, novas let me know what you have.
Last edited by gorace; 08-23-2010 at 12:28 PM.
03-30-2010, 10:34 AM
#2
Staging Lane
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Sacramento, CA
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Bump for a real nice one of a kind car, still debating about selling it as a complete turn key car hate to take it apart, it has a lme 402 trick flow heads jesel rockers. 545 rwp power etc etc. and m12 transmission drive train has 5000 miles. 25,000 for the complete car 10,000 for the complete roller
Last edited by gorace; 04-02-2010 at 12:31 AM.
Trending Topics
03-30-2010, 12:55 PM
#10
Staging Lane
iTrader: (1)
Join Date: Mar 2009
Location: Orangeburg S.C.
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
Oh how I wish you were in south carolina. I just paid 4400 for a car not half as nice as this one....not even a 3rd....doesn't hold a candle to this car........Dude cars nice
03-30-2010, 01:06 PM
#12
Staging Lane
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Sacramento, CA
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
I really would like to get 25000 for the car as a turn key car since I know that people are going to say thats way to much thats why I am willing to pull the motor and tranny to lower the price, really it comes down to what someone is looking for, I will sell the whole thing or sell it as a roller. I have 11,000 alone in the complete motor and and another 3500 in the tranny and clutch set up it also has a tick master and mcleod bellhousing.
03-30-2010, 01:15 PM
#15
Staging Lane
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Sacramento, CA
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
48000 miles on the chassis and I drive it on the street 99% of the time It run on 91 octane fuel, I have taken it to the track twice and ran 10.8 at 128mph with the tire trim you see toyo tq tires 315/35/18 with a 1.59 60 ft. But this car was is more towards handling threw the curves it has hotchkis sway bars also, 600lbs springs and 225 in the rear it rides very nice and firm. But doesn't beat you up the koni shocks keep everything under control
03-30-2010, 01:17 PM
#16
Teching In
Join Date: Feb 2005
Location: Kenosha, WI
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
The ad has no punctuation at all, but if you read it carefully then you'll see he's asking $5k without motor/trans (maybe other stuff, but I can't tell by the poor ad).
03-30-2010, 01:34 PM
#17
Staging Lane
Thread Starter
iTrader: (12)
Join Date: Apr 2008
Location: Sacramento, CA
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
I want 25000 for the car complete ready to go. I will take 10000 for the car minus engine and tranny. I can take more parts off the car to lower the price to make it more affordable like the rearend wheels and tires, brakes suspension stuff. I think Thats pretty fair you can throw in your own engine, transmission package and have one of the cleanest cars around. Sorry for any confusion it was late last night when I typed this up.
03-30-2010, 05:47 PM
#19
Damn it. HAHA I was almost driving to Sac tonight with $5K for this monster. I will admit as others said the ad is a bit misleading. EVERYONE here knows selling this as a roller for $5K would have been stupid, but are you saying none of this comes with it???
"things that don't come with the car is engine and tranny, wheels and tires the rearend is negoiable brakes, koni adj shocks with ground control coilover kit, everything umi offers for this car it has becool radiator, racetronix hot wire kit and pump, b and b exhaust kooks 1 7/8 headers, the rear end is narrowed 3 inches on each side and the car has z06 brakes all around"
If so for $5K I think it is right on target as you are getting a clean repainted car thats NOT a roller by no means. I will stick to my 550RWHP Z06 for now.
"things that don't come with the car is engine and tranny, wheels and tires the rearend is negoiable brakes, koni adj shocks with ground control coilover kit, everything umi offers for this car it has becool radiator, racetronix hot wire kit and pump, b and b exhaust kooks 1 7/8 headers, the rear end is narrowed 3 inches on each side and the car has z06 brakes all around"
If so for $5K I think it is right on target as you are getting a clean repainted car thats NOT a roller by no means. I will stick to my 550RWHP Z06 for now.