Notices
Vehicle Classifieds This an archive of the older vehicle classifieds, please create a new listing in our Marketplace.
Cars Search
Keyword:

Year:
(Range)

Make:

Model:

Price:

Mileage:

Private or Dealer Listing:

Location (State):

Color:

Transmission:

Drivetrain:

LS Engine?:


Parts Search
Keyword:

Category:

Price:

Part Fits:










Location (State):

Item Condition:

Engine:






LS Engine?:


Supercharged Corvette

Thread Tools
 
Search this Thread
 
Old 09-14-2013, 10:00 PM
  #1  
Teching In
Thread Starter
 
Speedaemonc4's Avatar
 
Join Date: Nov 2011
Posts: 0
Likes: 0
Received 0 Likes on 0 Posts
Default Supercharged Corvette

Year: 2000
Make: Chevrolet
Model: Corvette
Price: $19500
Mileage: 96000
Private or Dealer Listing: Private Listing
Location (State): TX
Color: Red
Transmission: Manual
Drivetrain: Rear Wheel Drive
LS Engine?: Car has LS engine

I have for sale a 2000 corvette convertible with major modifications all around. The car has 96xxx miles on the body, 60xxx miles on the motor, less than 10xxx on the rear end and transmission. Car is in very good condition. I am open to trades plus cash on your end as long as it evens out the difference. Car has around $30k in work and parts on it. I do have dyno sheets and track slips to back it up. Car has the full premium interior with Ice cold dual climate A/C, full leather, power seats, heads up display, and much more!

(Dyno sheet shows 627whp, My best times on track so far is 11.2 at 134 and 11.3 at 130, spinning the tires through first and second bad (1.9-2.0 second 60ft) With real drag tires it'd be an easy low 10 sec run. The current pulley on the supercharger is a 3.7, it produces 8-9 psi with the mods I have and isn't slipping. The car was retuned the first week in September for improved drivability, the meth is used for safety and the tune is geared towards engine longevity rather than performance. I have a 3.4 pulley that I had used a while back to get 10-11 psi but it slipped very badly (could only make 5psi) so I swapped the 3.7 on which is much better and isnt slipping.

Power Mods:

LS2 short block (from a 2005 C6)
ported and polished 317 heads (built for boost, lower compression)
P1sc Supercharger with Large front mount intercooler (Treadstone)
Alky twin jet methanol injection
80lb siemens deca injectors
Lingenfelter fuel pump and system (supports around 800hp)
LG Headers and X-pipe
Borla Stingers
Custom supercharger Cam
Yella Terra Rockers
Hardened pushrods (From Texas Speed)
Double Springs (for high lift cam)
Billet Timing chain
Fully Built MN12 Z06 6 speed Transmission
DTE Fully built rear differential
ECS Trans Brace
Phadt Trans Brace
Billet torque tube bushings
Monster Clutch
TICK adjustable Master Cylinder

Appearance mods:
Z06 Wheels
Plasti-dipped rear bumper and Grand Sport stripes (Can be peeled off in seconds with no damage to paint if you want car to just be red...)

Interior Mods:
Alpine Receiver
2x 1600 watt amps
10" Subwoofer
(don't know much about em, not really into sounds stuff)

Suspension Mods:
Bilstein Shocks

Asking 19,500 for the car. Most interested in a white TA or Firebird if a trade is involved, will consider others though, plan on a 1k hp drag build.

Feel free to hit me up with your offers, worst I can say is no...
Attached Thumbnails Supercharged Corvette-v1.jpg   Supercharged Corvette-v2_zpse78165b9.jpg   Supercharged Corvette-v3_zpsd216b69d.jpg   Supercharged Corvette-v4_zps632bd056.jpg   Supercharged Corvette-v5_zpsd216df52.jpg  

Supercharged Corvette-v6_zpsf60db5f0.jpg  
Old 09-15-2013, 03:24 PM
  #2  
Teching In
Thread Starter
 
Speedaemonc4's Avatar
 
Join Date: Nov 2011
Posts: 0
Likes: 0
Received 0 Likes on 0 Posts
Default

Bump, feel free to make offers, worst I can say is no..
Old 09-18-2013, 03:14 PM
  #3  
Teching In
Thread Starter
 
Speedaemonc4's Avatar
 
Join Date: Nov 2011
Posts: 0
Likes: 0
Received 0 Likes on 0 Posts
Default

Bump for today.
Old 09-29-2013, 08:30 PM
  #4  
11 Second Club
 
Kolk1's Avatar
 
Join Date: Feb 2005
Location: Alton IL
Posts: 176
Likes: 0
Received 0 Likes on 0 Posts

Default

99 Trans Am near stock just K&N intake and Flowmaster catback. Plus a Turbo Charged 2007 ZX-14? Completely refreshed bottom end, honed and replated, JE pistons, port and polished head, Garrett GT2871R turbo on 8.5lbs of boost. Stretched 8over, on and on. lol
Old 09-29-2013, 08:40 PM
  #5  
Teching In
Thread Starter
 
Speedaemonc4's Avatar
 
Join Date: Nov 2011
Posts: 0
Likes: 0
Received 0 Likes on 0 Posts
Default

Thats a badass sounding bike and exactly what I wanted some time ago, unfortunately now that Im married with kids I promised not to ride anymore for safety reasons, this city is really bad about running over bikers at stop lights. The Trans am you have interests me greatly though, Ill send ya a pm.



Quick Reply: Supercharged Corvette



All times are GMT -5. The time now is 11:33 AM.