1992 Firebird for sale - 350 TPI
03-23-2007, 07:07 AM
#1
TECH Apprentice
Thread Starter
iTrader: (13)
Join Date: Aug 2003
Location: Wake Forest, NC
Posts: 355
Likes: 0
Received 0 Likes
on
0 Posts
1992 Firebird for sale - 350 TPI Car has a 350 TPI with probably about 2000 miles on it. Exterior is pretty nice, just needs a cleaning. Bumpers have some scratches and things, but the car is a good driver and would clean up nice. Interior needs work. Seats are ok, carpet is dirty, headliner is gone as are the sunvisors. Plastic and door panels are nice, though.
Also has a BMR 3-pt STB and an SLP CAI on it. Battery has been relocated to the trunk, but I haven't had a chance to finish that part of it. Still need to run ground wire. Car will run good, but only till the battery runs out of juice. I'm going to try and run it before we sell the car, but can't promise you anything. Right now, plan to tow it out of here. It's an easy fix I think, but I just don't have the time to finish it with the baby and all.
Here are the engine specs:
350 flat-tappet motor
3-angle job, etc on heads
Comp XE268H cam - 268/280 .477/.480 114cl
24lb injectors
Crane AFPR
Accel cap and rotor
Accel 8.8 wires
Hooker shorties
Custom y-pipe with exhaust cuout
Flowmaster muffler
We need $3000 firm for it. We have a LOT more money than that in it, but needs work to be finished. Would make a good car for someone with the time to get into it. Engine alone is worth a few grand.
Car also has a new radiator, starter, battery, and MAF sensor.
Car is also a t-top automatic car with about 100k on it
Also has a BMR 3-pt STB and an SLP CAI on it. Battery has been relocated to the trunk, but I haven't had a chance to finish that part of it. Still need to run ground wire. Car will run good, but only till the battery runs out of juice. I'm going to try and run it before we sell the car, but can't promise you anything. Right now, plan to tow it out of here. It's an easy fix I think, but I just don't have the time to finish it with the baby and all.
Here are the engine specs:
350 flat-tappet motor
3-angle job, etc on heads
Comp XE268H cam - 268/280 .477/.480 114cl
24lb injectors
Crane AFPR
Accel cap and rotor
Accel 8.8 wires
Hooker shorties
Custom y-pipe with exhaust cuout
Flowmaster muffler
We need $3000 firm for it. We have a LOT more money than that in it, but needs work to be finished. Would make a good car for someone with the time to get into it. Engine alone is worth a few grand.
Car also has a new radiator, starter, battery, and MAF sensor.
Car is also a t-top automatic car with about 100k on it
Last edited by 4Birdman; 03-26-2007 at 07:53 AM.
