383 LT1 Trans Am

Thread Tools

Search this Thread

07-07-2008, 03:54 AM

BLK95TA

Teching In

Thread Starter

iTrader: (1)

Join Date: Nov 2001

Location: Texarkana, Tx

Posts: 9

Likes: 0

Received 0 Likes on 0 Posts

383 LT1 Trans Am

Car is a 95 with 100,300 miles. The engine has about 10,000. Pretty nice vehicle, interior is in nice shape except for wear on the bolster on the drivers side. The car was originally an A4 but has been converted to a T56. Pretty clean car both in and out. Sounds like a freight train and is sure to draw attention ANYWHERE. Car made 409hp/430tq through the A4 and 2 1/2 ypipe. I'm willing to bet about 30 more could be made with the current T56 and freer flowing exhaust with a little more tuning. Idea was originally to use nitrous. Car would make well over 600hp with a 200 shot. Air blows cold. $8500 obo

Engine:
383 LT4, AFR, solid roller
11.9:1 compression (93 octane friendly)
Eagle forged crank
Mahle forged pistons
Eagle forged rods
Callies billet 4 bolt caps
Canton 6qt oil pan
Canton pickup
Melling pump
Cam motions solid roller (247/250 .658/.659 112)
Crane 11522 solid roller lifters
JESEL SHAFT MOUNT rockers 1.6 (.150" offset on intake side)
Comp cams 943 pacalloy springs(3k miles)
Comp cams Titanium retainers
Comp cams 10 degree locks
Proform Die-Cast Aluminum Chevrolet Valve Covers
AFR 210 LT4 heads ported/sleeved by Mark Montalvo/B&B racing in California
59.5cc combustion chambers
2.10/1.625" Ferrera 6000 valves
FelPro 1074 head gaskets
ARP headbolts
LT4 intake manifold (ported, cut for monoblade)
FelPro 1206 intake gaskets
Cloyes double roller timing chain
95+ timing cover
Arizona Speed and Marine monoblade TB (1300cfm)
stock LT1/LT4 fuel rails with SLP adjustable fuel pressure regulator
Lucas 38# injectors
K&N Cold Air Kit
Vortech Polished elbow
Meziere electric water pump

Transmission
T56 6 speed
Mcleod 7000rpm clutch
Lou's short stick shifter
shift light

Suspension
BMR Chromoly adjustable torque arm
BMR panhard bar
BMR rear control arms
BMR Subframe connectors(new, not on car)
Moser 9" 31 spline

Exhaust
Hooker headers
Custom built true dual X pipe dumped before axle
bullet mufflers
dummy chrome rolled lip exhaust tips

Igniton/Fuel/PCM
Dyno tune by Jeff Creech Carolina Auto masters
Walbro 255lph Race Pump w/ racetronix wiring harness
Adjustable FPR
MSD 6AL w/ MSD coil
Autolite 3923 plugs
Taylor wires

Exterior
SLP Ram Air Hood
17" Firehawk rims
Red vinyl decals
Cooper Zeon's front/Nitto drags on rear 275/40/17

Audio
stock head unit(tape player doesnt work)
EQ with xover
two amps..one for highs/lows two subs

Car also has a LT1 scanmaster mounted on the dash and makes for an excellent conversation piece. Just installed the Autotrix passenger window fix. Factory Service manuals for 94-95 Fbody cars. I also have copies of tunercat and datamaster with cable I can give to buyer.