Stuck
Thread Starter
Launching!
iTrader: (14)
Joined: Feb 2007
Posts: 293
Likes: 0
From: Rancho Cucamonga, CA
Stuck well since i was changing the alternator i said screw it and started changing the rack and pinion and now i cant get the dam bolt out on the driver side anyone ever deal with this while changing the rack?
yup. had to unbolt the motor mounts (can't remember if it was just one or both), jack the engine up a bit, then remove the bolt. as far as i know, this is the only way to remove that stupid *** thing. then make sure you turn the bolt the other way around when you install it so you don't have to do that again.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo Thread Starter
Launching!
iTrader: (14)
Joined: Feb 2007
Posts: 293
Likes: 0
From: Rancho Cucamonga, CA
Done its finally done got everything back together ended up having to take ac off to take the other mount off. So rack is in alternator wire fixed and i am one tired guy thanks for all the suggestion guys
