FTMFW!!!!! Its finally running
01-14-2009, 03:22 PM
#24
On The Tree
Thread Starter
iTrader: (4)
Join Date: Jan 2008
Location: Lynwood
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
lol i plan to lmao fucken tops are expensive wel including install. Seems real complicated for me to even try and tackle that project.
I'm going to show up to a meet with the top down wearing a big *** jacket snow gloves and a beenie lmao
I'm going to show up to a meet with the top down wearing a big *** jacket snow gloves and a beenie lmao
01-14-2009, 04:48 PM
#27
I bought a 91 RS Vert well a long time ago lol probably under a year ago. Swapped out the blown motor, did a t5 swap and well it finally started. Took so long mainly due to lazyness but it finally started
But now the issue is that its running extremely rich. I posted on www.thirdgen.org and they're telling me it may be because it used to have a 350 and I threw in a 305 I had laying around so the injectors are supplying way too much fuel. I also remembered that the guy i bought it from said it had a hypertech chip so i'm gonna remove it and install the stock tbi chip. Now to look for a crashed 91-92 z28 to buy and take the tpi from 
But now the issue is that its running extremely rich. I posted on www.thirdgen.org and they're telling me it may be because it used to have a 350 and I threw in a 305 I had laying around so the injectors are supplying way too much fuel. I also remembered that the guy i bought it from said it had a hypertech chip so i'm gonna remove it and install the stock tbi chip. Now to look for a crashed 91-92 z28 to buy and take the tpi from 
01-15-2009, 10:17 AM
#31
On The Tree
Thread Starter
iTrader: (4)
Join Date: Jan 2008
Location: Lynwood
Posts: 190
Likes: 0
Received 0 Likes
on
0 Posts
I swapped in the ecm from my 89 parts car. Its also a 5spd l03 and it idled better. I put fluid in the trans then started it up and went to put it in gear and it wouldn't go in. Completely forgot about bleeding my clutch hydrolics
01-15-2009, 02:58 PM
#33
On The Tree
iTrader: (4)
Join Date: Feb 2008
Location: Riverside, CA
Posts: 166
Likes: 0
Received 0 Likes
on
0 Posts
I hope it is running before march, that seems reasonable. My buddy and I are trying to get thru the wiring, I have to get a hose to the radiator, drill a hole for wiring, and connect all the fuel crap. if wiring was done I think it could be running by the end of this month. Still got paint and crap too.
