Wicked_muscle

iTrader: (34)

I cleaned it up and primed it gonna spray it in ten minutes. Gotta get the bearings pressed on in the morning and get the u joint for the drive shaft then throw it in. It looks bad *** cuz I got it with the back brace and everything.

Anthony Williams

iTrader: (3)

Yep, but I will try and make it

Revelation Z28

iTrader: (10)

3.90s? or 4.11? **** you shouldda told me something i wouldve helped you out

Wicked_muscle

iTrader: (34)

Center section is a nodular case with daytona main caps. All new seals, bearings and 4.11 gears. Taking longer than I thought to install but that's because of super duper shitty install instructions from moser. Can't even tell the order of the bearings that need to be pressed on the new axles. Plus I primed the housing earlier then painting it. I just wanted everything that I figured I might need in the future and doing the painting right the first time.

Revelation Z28

iTrader: (10)

yea and with your luck if you break this one we are all gonna laugh, even if its the almighty 9".. i still need to register the car so im not gonna be down there for another couple weeks or so.

Wicked_muscle

iTrader: (34)

I do have shitty luck. What's up with the registration taking so long? Moolah?

Revelation Z28

iTrader: (10)

yuuup its $240 to register it it went up $80 since they raised the prices.

Wicked_muscle

iTrader: (34)

Damn that sucks! Don't let it get to late that they charge you a late fee.

Wicked_muscle

iTrader: (34)

Bump for tonight. Gotta throw the rear end in and bleed the brakes.

BeemerZ28

iTrader: (5)

how long you guys usually meet for? rolled by about 830 and no one there.

DrifterFreak210

iTrader: (7)

We normally go for a while, but it got canceled on the fact that no one showed up. I rolled through at right about the same time, 840 ish and no one.

BeemerZ28

iTrader: (5)

ok that's what I figured. was trying to come by and check out the group.