DynoPro.
Sunday, April 30th
10:00 AM
6231 Beach St
Denver, CO
303-455-2443

Three Baseline runs - $50

Mapquest still does not pull Bear's new address up.
You need to get to 64th and Federal (Rocky's Autos is on the southeast corner) and head east on 64th about a mile to Beach. Take a right, the shop is on the right about 1/2 mile in.

 

No one is up for this eh??

 

I was thinking about going to Bandimere that day.

It would be nice to see what kind of numbers I have now with the headers/exhaust/converter though.

 

I maybe up for it if I have my tranny in

 

It coudl be worth the trip, I'll see if someone can't get the car down there for some pulls. IF the PCM is back in time...

 

I really hope to see as many of you guys as possible!!!

Should be a fun day.

 

Hrm, after watching the video you posted I'm tempted to go now just to see your car.

 

I will be dynoing.
Not sure if you will see it run to 6600 though.

Won't be fully tuned I don't think. Just gonna keep a real close eye on Bear's wideband. Leans out even a little and it is coming off the rollers.

 

Hey whats up guys! Hey got a ? for ya! I have Long tubes, high flow y-pipe and cats, Slp bellow and air lid and flowmaster cat back. i ran opening day and bandimere my best at 13.58 and 102.71 do u think that's repectible for the few things that i have done? or u think it should be faster? i have a 2001 Z28

 

Also that ET was at bandimere Elevation:6500 keep in mind? so what do u guys think?

 

Bandimere is 5800 feet above sea level.

And those are better than my times and I was cammed.
Respectable?? I would say so.

 

That's damn good considering what I ran the last time I was there. I'm still trying to get in to the 13's.

 

Tomorrow morning!!!

 

To The Top for ya Curtis......Might make it myself????????

 

512.6 RWHP
462.0 ft/pounds

Not bad. Still needs a complete tune.