rubbing on right turns? cornering!
Thread Starter
Banned
iTrader: (8)
Joined: Jun 2007
Posts: 3,093
Likes: 1
From: san fernando valley, california
rubbing on right turns? cornering! hey guys, well currently in the back of my car has a BMR adjustable PHB,BMR LCA, tokico shocks, and vogtland springs, and 255/50/16's i have my PHB adjusted already and its pretty straight now, but i noticed when i corner a bit hard in a right turn i can hear some type of rubbing from the rear! what would you guys think it it? maybe the nut on the PHB came loose? i am going to buy a upgraded rear swaybar soon maybe 23mm will that fix my problem??
Check for signs of rubbing. Tryo to find the source of the rubbing before you waste money on the wrong "fix".
I had that issue twice. The first time it was the passenger tire, the second time it was the tire on the inner fender. (bet it has 315's lol)
I had that issue twice. The first time it was the passenger tire, the second time it was the tire on the inner fender. (bet it has 315's lol)
lol, only 255's and rubbing, there has to be a problem with your adj maybe its inner fender and just havent noticed yet, you need to go down there and look, then get some real tires on that car. lol
Trending Topics
My car used to rub in hard turns heading up to big bear but i had 295 30 19's on the back at the time. just check for the rub mark and smash it in, but it sure does seem strange that it would do that with the smaller size of these tires.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo Thread Starter
Banned
iTrader: (8)
Joined: Jun 2007
Posts: 3,093
Likes: 1
From: san fernando valley, california
i just saw my problem, its a very very light rub on the bump stop on the left rear wheel! its very light, i can only tell since the wheel is a little clean! but i think it may be my panhard bar but it looks pretty even! i may just move that wheel a tiny bit out to solve the problem!
Thread Starter
Banned
iTrader: (8)
Joined: Jun 2007
Posts: 3,093
Likes: 1
From: san fernando valley, california
im already taken right hand turns at like 40 2nd gear on throttle, i may just leave this alone until i install my other wheels, and i want to get my swaybar soon too!
i just saw my problem, its a very very light rub on the bump stop on the left rear wheel! its very light, i can only tell since the wheel is a little clean! but i think it may be my panhard bar but it looks pretty even! i may just move that wheel a tiny bit out to solve the problem!
Thread Starter
Banned
iTrader: (8)
Joined: Jun 2007
Posts: 3,093
Likes: 1
From: san fernando valley, california
hope it helps 
Not sure why you'd be rubbing with such a small rear tire. I'm lowered, and have 315's in the back. I had to roll finders and hammer on the inside well though. But even prior to that, bumpstops never got in the way. Now, I don't scrape anywhere.
Maybe panhard adjusments are off? Just alittle confused why you'd scrape with such a small tire, and I'm assuming stock height??
Maybe panhard adjusments are off? Just alittle confused why you'd scrape with such a small tire, and I'm assuming stock height??
Thread Starter
Banned
iTrader: (8)
Joined: Jun 2007
Posts: 3,093
Likes: 1
From: san fernando valley, california
Not sure why you'd be rubbing with such a small rear tire. I'm lowered, and have 315's in the back. I had to roll finders and hammer on the inside well though. But even prior to that, bumpstops never got in the way. Now, I don't scrape anywhere.
Maybe panhard adjusments are off? Just alittle confused why you'd scrape with such a small tire, and I'm assuming stock height??
Maybe panhard adjusments are off? Just alittle confused why you'd scrape with such a small tire, and I'm assuming stock height??
