ah fak!
ah fak! Well I had a shop weld a cutout on my exhaust. Good job done on the weld. But then as im trying to install my QTP plate i realize the cutout was welded too much to the front of the car and too close to the floor board. Damn QTP motor didnt fit. So i tried to bang the floorboard in. FAIL cuz i dont wanna *** it up further. So now i have to go back and have the guy do some mickey mouse **** and have my qtp motor fit. Oh well mostly my fault
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
I feel your pain, I had a manual one welded in as well and he was supposed to use a demo electric to get the angle right, well sure enough off by a 1/4 inch or so and so I had to install it upside down so it hangs low (temp solution) also the bolts on the manual are not long enough to fit the electrics I found and they are tack welded to the cutout. so I had to grind them off to fit longer bolts.
Last edited by Stroker396@APF; Aug 11, 2008 at 09:39 AM. Reason: So tired, it read like I was drunk when I typed it.
I feep your pain, I had a manual one welded in as well and he was supposed to us a demo electric to get the angle right, well sure enough off by a 1/4 in or so and so I had to instal it upside down so it hands low (temp solution) also the bolts on the manueal are not long enpought to fit the electrics I fopund and they are tack welded to the cutout. so I had to grind them off to fit longer bolts.