NBM ROLLER 9in cage ect built
Thread Starter
Teching In
Joined: Apr 2011
Posts: 12
Likes: 0
NBM ROLLER 9in cage ect built Thinking about pulling the engine, trans and engine harness from my car to put in another project... Well here's a rundown.... 1998 NBM ls1 6spd car. It's got a mosier 9in with 3.73's detroit upgraded aluminum pinion support and a 1350 yoke. Its got a denny's aluminum driveshaft. All the rear end links are tubular non-adjustable. Bmr adjustble frame mounted torque arm. Bmr subframe connectors (welded). Bmk K member... Prostar wheels , momo steering wheel, line lock, professionally built 6pt cage (nicely done)
63k miles interior is about a 7.5 (worn carpet, stain on drivers seat)
exterior is a 9 (few scratches towards bottom of bumper)
Only bad thing is a story from the previous owner it slung a driveshaft, hit a airbag sensor and blew the bags on the strip.
Clean and clear SC Title
Dead stock shocks and springs... overall nice car
63k miles interior is about a 7.5 (worn carpet, stain on drivers seat)
exterior is a 9 (few scratches towards bottom of bumper)
Only bad thing is a story from the previous owner it slung a driveshaft, hit a airbag sensor and blew the bags on the strip.
Clean and clear SC Title
Dead stock shocks and springs... overall nice car
