ZR1's w/ 50mm or 36mm offset???
#1
On The Tree
Thread Starter
iTrader: (20)
Join Date: Dec 2004
Location: Garland, TX/Jacksonville, FL
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
ZR1's w/ 50mm or 36mm offset???
I'm trying to figure which offset I wanna go with with a Narrowed rearend. I am looking into buying the rearend narrowed 1" on each side. If my math is correct. The 36mm will move the mounting surface in 1.42" while the 50mm offset would be at 1.97". Basically a difference of .55". My fenders are rolled and I have had 17X11's w/315's on before (50mm I believe) with no rubbing issue. Do you guys think this will work? And any pics of 36mm 17X11's would be great. Oh yeah, I am looking for the wheel to have an lip as well
#2
TECH Enthusiast
iTrader: (2)
Join Date: Feb 2004
Location: Washington
Posts: 577
Likes: 0
Received 0 Likes
on
0 Posts
At 1" per side narrowed the 50mm will not bolt on without modifying the wheel well. The 36mm "might" bolt on but you will need to modify the wheel well to drive it. I have a large hammer you may barrow, but with the cost of shipping you may be better off just buying one down there.
#4
On The Tree
Thread Starter
iTrader: (20)
Join Date: Dec 2004
Location: Garland, TX/Jacksonville, FL
Posts: 105
Likes: 0
Received 0 Likes
on
0 Posts
At 1" per side narrowed the 50mm will not bolt on without modifying the wheel well. The 36mm "might" bolt on but you will need to modify the wheel well to drive it. I have a large hammer you may barrow, but with the cost of shipping you may be better off just buying one down there.