I heard 15x4 and 15x10 Billet Specialty wheels are in the house!
#23
Sure would be, if they offered the correct backspacing for the front wheels! Look at an Alumastar with a 2.25" backspace on the 3.5" wheel, THAT is how a front wheel SHOULD fit on a Camaro.
I am sure Billet will address this though since they did fix the rear wheels to be LS1 specific!
I am sure Billet will address this though since they did fix the rear wheels to be LS1 specific!
#24
Got them put on today!
Had to grind the front calipers a little. It is aluminum and basically takes 2 minutes a side. All you are doing is putting a nice radius on the sharp edge. Cake! As for the rear we may/may not have done mine the same as others. As you can see in the pic with the rear hanging the tire was extremely close to the bumpstop. We decided to move the bump stop in at the rear point using the front mounting bolt (I have no idea why GM put a tab to make them crooked) only and a zip-tie through the rear bolt with it slid over. It isn't going anywhere. I have one pic of the car outside with the Speedlines and a couple of crappy ones I did with the wheels on inside. All four mods that we did to fit the wheels can be done in 30 minutes.
Last edited by Intercooler2; 01-17-2009 at 07:57 PM.