Z06 Wheel Issues.
#1
Teching In
Thread Starter
Join Date: Mar 2008
Location: Kent Washington
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
Z06 Wheel Issues.
I have a 02 Z28 and just got some Z06 wheels from a 02 Z06. They came with a 315-35-18 Nitto Drag Radial on the back and a 275-40-17 Nitto drag Radial in the front. I took a hammer to the inner fender to give a little room. I would like to have about the same size sidewall in the front and the back and I dont really want a different size tire in the back, I like the one that is on it. Would a 275-35-17 accomplish the look that I want? The back is still rubbing a litle when im hammer down in a corner. Would I be able to run about a 1/4 inch wheel spacer to fix this problem or would that put my tire into my finder lip? Also are the stock lugs long enough to fit a wheel spacer if I go with that idea?
#4
12 Second Club
iTrader: (16)
Join Date: Mar 2008
Location: Amarillo, Texas
Posts: 444
Likes: 0
Received 0 Likes
on
0 Posts
well i just went through this kinda smething with my zo6's. i ran a 1/4" spacers for the rear and it seemed to help a little and it looks great, but i still am going to half to do a little room making. if i get to crossed up it rubs slightly.
#5
Teching In
Thread Starter
Join Date: Mar 2008
Location: Kent Washington
Posts: 43
Likes: 0
Received 0 Likes
on
0 Posts
Is the rear centered with an adjustable PH Bar?
And no on the spacer with stock studs. The factory studs are not threaded to the end and it would be too short.
I wouldn't recommend a spacer unless you went with ARP studs.
And no on the spacer with stock studs. The factory studs are not threaded to the end and it would be too short.
I wouldn't recommend a spacer unless you went with ARP studs.
well i just went through this kinda smething with my zo6's. i ran a 1/4" spacers for the rear and it seemed to help a little and it looks great, but i still am going to half to do a little room making. if i get to crossed up it rubs slightly.