98Z2885

Thanks, its gonna look awesome once I get them all cleaned up and installed. Its taking forever to get them on...

98Z2885

bump for new pictures/

Magnet

iTrader: (36)

looks good.. you need a little drop and definitely some tire wet though! Tire wet is a necessity

IWGF

iTrader: (6)

I like 'em man. What size spacers are you running though? They stick out much farther than mine, mine tuck real nice with 5/16" spacers and ground calipers.

98Z2885

5/16ths as well. I dont like how they sit in the rear though. I traded wheels with my dad fo the deep dish. Can I grind the calipers down any? I tried it with out the spacer and it rolled but was dragging a little bit. Ill tire wet them tomorrow. Ive been up for 14 hrs. It took me 2 hrs just to get 3 wheels on. Ill take some more pictures tomorrow when Its sunny.

IWGF

iTrader: (6)

Yes, you can grind the hell out of the calipers. I spent 6 hours grinding mine. There's a pic of my car sittin on the 'stars here on this forum... I'll find you a link. There's also caliper grinding write ups around here.

98Z2885

I did grind it down some. It is not hitting by much, I drove the car up the street. I can just hear it a little bit.

IWGF

iTrader: (6)

https://ls1tech.com/forums/wheels-ti...-prostars.html

There's my car on Prostars. Strange how well mine tucks compared to yours when we're running the same setup.

98Z2885

Thanks for the link, my car fit like that, when I had the 8" backs and nitto 275 60's. Im running a 275 50 now and a 10" wheel. I am going to have to figure out whats going on. I hope the back spacing isnt different. They tucked real nice under my dads car.

IWGF

iTrader: (6)

From the looks of it, I'd say the backspacing is different... I'm running the 8" wheels.

98Z2885

Ill figure it out, even if I have to go buy two other wheels and have them powder coated. I think its the spacer doing it.

IWGF

iTrader: (6)

I dunno man, I don't think it's the spacer. But a good way to check is to just put them on w/o the spacers, just put the lugnuts on to hold the wheel on, and take it off the jackstand, see if that solves the issue, then go from there.

02gtp4now

iTrader: (7)

damn that looks mean

98Z2885

Thanks