Who's running Torq Thrust M's?
and we can fit a way wider tire 
04-23-2010, 08:57 AM
#23
I put old school PMD (Pontiac Motor Division) centers on mine and get compliments all the time. Trying to mimic the old PMD Rallye rims.
I have yet to see someone put SS center on them. On mine it was an easy swap had to buy a longer bolt to hold them on that was it.
http://www.early-birds.ca/part-86887.html
04-23-2010, 09:52 AM
#24
They do, but if you change the center caps it does change the look of the wheel.
I put old school PMD (Pontiac Motor Division) centers on mine and get compliments all the time. Trying to mimic the old PMD Rallye rims.
I have yet to see someone put SS center on them. On mine it was an easy swap had to buy a longer bolt to hold them on that was it.
http://www.early-birds.ca/part-86887.html
I put old school PMD (Pontiac Motor Division) centers on mine and get compliments all the time. Trying to mimic the old PMD Rallye rims.
I have yet to see someone put SS center on them. On mine it was an easy swap had to buy a longer bolt to hold them on that was it.
http://www.early-birds.ca/part-86887.html
04-26-2010, 02:01 PM
#25
12 Second Club
thats interesting i wouldn't mind trying that i never was a fan of the stock caps on these wheels kinda wish i woulda got the tt2's but then i would have had to have them powdercoated
04-29-2010, 09:36 AM
#26
Teching In
Join Date: Jun 2003
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
hot damn, i must have these on my firehawk. Been doing some looking around for best pricing on a set of the anthracites. Looks like Tirerack wants 187 per wheel (and i cant find the 10.5" rears on the site). And Jegs wants 181. Anyone know of any better pricing out there? I'm assuming the 44mm offset is the way to go for these on the rears since its the only 4.75 bolt pattern offered? see below.
Torq-Thrust M Series - Anthracite Finish
American Racing Center Cap
Size: 17'' x 10.5''
Bolt Pattern: 5 x 4.75''
Offset: 44mm
Torq-Thrust M Series - Anthracite Finish
American Racing Center Cap
Size: 17'' x 10.5''
Bolt Pattern: 5 x 4.75''
Offset: 44mm
04-30-2010, 10:30 PM
#29
Teching In
Join Date: Apr 2010
Location: Corpus Christi, Texas
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
I am running the TTM's. 17 x 9 in front with 275's and 17 x 10.5 in back with 315's. Went through five sets of TT2's but couldn't find enough of them round and straight enough to complete a set. The TTM's are much better and easy to maintain. Good luck !
05-01-2010, 11:26 PM
#30
