315/60/15
Depends on the car..some say they did nothing, some say they had to beat the living **** out of there car to make them fit. A lot of it depends on backspacing on the wheel. Mine is a Narrowed Rear 2.5in each side, 5.5in backspacing on the wheels, so they set half an inch inside. I had to beat the hell out of mine to get them to fit. Im 125lbs and I made it happen, so I have faith that anyone can make them fit. I did have to cut my bump stops off also..
Trending Topics
Registered User
Joined: Mar 2010
Posts: 34
Likes: 0
From: davison
i had to clearance my front lower inners with a bfh but didnt hurt anything and they just barelty touch on the outer lips just enough to rub but no cuts roll the lip and ill be fine but my car is lowered couple inches on a 97
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
TECH Regular
Joined: May 2008
Posts: 460
Likes: 0
From: St.Louis Missouri
What tire did you end up sticking with the best on your car??? My car sit's up extremely high cuz of the rear suspension set-up so i know for a fact that i'm in good shape for almost a 30inch tire just maybe not a 13.5 width to have to beat the fenders in... Will it be the best tire for nitrous an high Hp applications with a 4:10 gear an a M6?
What tire did you end up sticking with the best on your car??? My car sit's up extremely high cuz of the rear suspension set-up so i know for a fact that i'm in good shape for almost a 30inch tire just maybe not a 13.5 width to have to beat the fenders in... Will it be the best tire for nitrous an high Hp applications with a 4:10 gear an a M6?
I tryed the Hoosier 325/50 Radials and they did OK..I went to a bias ply now but the radials were fun..I was still pulling the tires on radials but took a bit more work to make the car leave good!
