Weld RTS wheels need grinding
Weld RTS wheels need grinding Am I the only onr who needs to grind, very little, off the top of the calipers to get these wheels to fit? Just a little off the top rear, kinda looks like three fingers, just barely touch enough to leave a mark on the wheel. What were the damn odds......
On The Tree
Joined: Jun 2009
Posts: 160
Likes: 0
From: Kansas City
Grinding It depends on where and when your barkes were produced. I have seen some applications where the right side will clear but the left won't due to the caliper source the mfg purchased the product from. Even a case where the calipers were made at the end of a mold cycle and the tolerances have changed slightly from the original spec. Not very common but once in a while it happens.
