RPM 505's 19x9.5 on all 4 corners? Anyone do it?
12-22-2011, 03:59 PM
#1
Teching In
Thread Starter
Join Date: Mar 2011
Location: Saratoga Springs, NY
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
RPM 505's 19x9.5 on all 4 corners? Anyone do it? I am looking to see if anyone has pics of RPM 505 19x9.5 on all four corners of a 4th gen camaro or trans am.
I have see alot of people staggering them 9.5 wide in the rear and 8.5 in the front, but I have not found 9.5 on all four corners. Please post up some pics if you have done it! Also let me know if spacers were needed to make it look correct. I don't want the front wheels hanging out of the wheel wells.
Thanx for any help!
I have see alot of people staggering them 9.5 wide in the rear and 8.5 in the front, but I have not found 9.5 on all four corners. Please post up some pics if you have done it! Also let me know if spacers were needed to make it look correct. I don't want the front wheels hanging out of the wheel wells.
Thanx for any help!
12-29-2011, 02:03 AM
#2
Launching!
iTrader: (21)
Join Date: Nov 2008
Location: Slidell, LA
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
Im curious to this as well. IM running 18x10 on longer ARP studs and 1/4" spacers all the way around now so i dont think it would be an issue/
But im looking for a set of 19" 505s, i wish they came made more for our cars.
But im looking for a set of 19" 505s, i wish they came made more for our cars.
12-29-2011, 02:42 AM
#3
TECH Resident
iTrader: (6)
Join Date: Sep 2008
Location: SoCal, SFV
Posts: 793
Likes: 0
Received 0 Likes
on
0 Posts
Yes people have run 9.5s all the way around. I prefer the staggered look on Camaros though. Birds pull off the deep dish all the way around better. Look for Carlos' LT1 Trans Am. You can find pics of his car in just about any RPM505 thread.
12-29-2011, 11:57 AM
#5
Teching In
Thread Starter
Join Date: Mar 2011
Location: Saratoga Springs, NY
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Carlos, I noticed your rear wheels are wide to say the least! I have looked for RPM 505's wider than 9.5 but have not found them. Where did you buy yours and what width are they?
12-29-2011, 03:24 PM
#6
TECH Enthusiast
Join Date: Jun 2010
Location: Illinois
Posts: 611
Likes: 0
Received 0 Likes
on
0 Posts
he has his professionally widened. from what I know, they do not mkae the rpm505's anymore. I could be wrong, but even when they were being produced, the widest they made was a 9.5
12-29-2011, 05:27 PM
#7
