VandykeT/A

Right now on my WS6 I'm running a 17x9 up front and a 17x11 in the back. 275-40-17 and a 315-35-17. Its just about time for rear tires but I was wondering if I could get any wider. I've all ready trimmed the bump stops and did the BFH mod just for insurance but I probably wouldn't have needed it. Do you think a 335 will fit without and problems? I'm also about to be lowered on Stranos and If I can I'd like to go a little wider up front as well. Thanks

Guitar

iTrader: (9)

315 is as wide as I'd go for 11".

VinR1

iTrader: (17)

335s will fit...just make sure you have an adj phb, fenders are rolled, and keep a big hammer handy. If your offset is ok, the hammer may not be needed

tvg001

iTrader: (1)

335 will be the widest my friend had it on some zr1 and they fit good no rubbing , he didnt have the adj phb or the fenders rolled only did the bfh mod to it

MasterTomos

iTrader: (15)

I'd be really hesitant to put 335's on my car if it were lowered. It will probably really depend on the brand of tire, too. Many people have to do the BFH/PHB/bumpstip trim/fender rolling to run 315's, let alone 335's, at stock height.

Also, other than they look badass, there is no reason you need 335's.

VandykeT/A

I'm not sure what the offset is but they're TTII's bought for an Fbody. I just want them for looks. I'm kind of worried about rolling the fenders. Whats the best way to do. Put a baseball bat between it and the tire? What about on the front to? And with a 335 do I need to drop to a 30?

MasterTomos

iTrader: (15)

They have fender rolling kits for rent on some websites that uses a special tool. Some people use a rag/heatgun/pliers but Im not that brave.

carlos64030

iTrader: (5)

I used a $5 mini wooden baseball bat from Walmart to roll my fender lips. It worked perfectly for me since my car sits so low. I had to slightly Jack up the car so I could get the bat between the tire and fender. That trick may not work so well if your car isn't low enough.

lees02WS6

iTrader: (5)

What kind of tires are those? Does cornering hard cause rubbing on the inside fender?

lees02WS6

iTrader: (5)

Member 69TA rents the roller tool, and a heat gun. That is who I rented one from.

98BLOWNZ28

iTrader: (10)

What tire is that?

camaroboy14

iTrader: (8)

Wow 335s look sick !!

VinR1

iTrader: (17)

Theyre actually 315 BFG KDs but just a hair wider than the 335 Hoosiers in my garage. My wheels are 36mm offset and the only, and I mean ONLY rubbing Ive had is the outer drivers side on extreme right turns

BOBS99SS

iTrader: (2)

hit up 69ta ,he rents the tool to roll fenders

BOBS99SS

iTrader: (2)

https://ls1tech.com/forums/wheels...ol-rent-5.html