In case anyone has wondered. A Weld RTS Mid pad will fit a Wilwood Narrowlite 13" kit
07-20-2015, 02:43 PM
#1
In case anyone has wondered. A Weld RTS Mid pad will fit a Wilwood Narrowlite 13" kit I just got my track use Weld's today and have been nervous, as I ordered 18x11s for all 4 corners 43mm offset and could not get 11" wide in a high pad, so these are Mid pads.
I knew my Wilwoods were narrower than most BBKs.
This is the kit I have.
http://www.wilwood.com/BrakeKits/Bra...temno=140-9833
The stock WS6 wheels fit too.
I would not buy a brake kit till I upgraded the bearings, so I put the X Trakker kit on it as well.
Pics.
Stock WS6 over them.
As well as over AR TTMs.
I ordered a set of CCW D240s yesterday as well. Very excited to see how they look on the car.
I knew my Wilwoods were narrower than most BBKs.
This is the kit I have.
http://www.wilwood.com/BrakeKits/Bra...temno=140-9833
The stock WS6 wheels fit too.
I would not buy a brake kit till I upgraded the bearings, so I put the X Trakker kit on it as well.
Pics.
Stock WS6 over them.
As well as over AR TTMs.
I ordered a set of CCW D240s yesterday as well. Very excited to see how they look on the car.
