315 gsd3 or 335
#25
TECH Fanatic
iTrader: (12)
Join Date: Oct 2006
Location: Orlando, FL
Posts: 1,724
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by blackmaro99
LS1Kid, your car looks badass. BTW, what offset did you go with and how much BFHing did you have to do?
They are 17x11 ZR1's with a +50mm offset.
The BFH was not bad at all. I was worried it was going to be a **** load of work but it wasnt. It didnt take long at all and I was taking my sweet *** time.
My rear end is not perfectly centered so i did notch one of my LCA's just for piece of mind. The tire was close to it but not rubbing.
I would reccommend an adjustable PHB and some tubular LCA's but it is NOT NEEDED.
Hope I could help.
#26
TECH Regular
iTrader: (5)
Join Date: Oct 2006
Location: Atlanta, Georgia
Posts: 430
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the info, you talked me into it!
edit: How much is an adjustable panhard bar going to cost me? I have no idea where to look for this and my search isn't working. I'm assuming I'll have to pay someone to put it on for me as well.
edit: How much is an adjustable panhard bar going to cost me? I have no idea where to look for this and my search isn't working. I'm assuming I'll have to pay someone to put it on for me as well.
#27
TECH Fanatic
iTrader: (12)
Join Date: Oct 2006
Location: Orlando, FL
Posts: 1,724
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by blackmaro99
Thanks for the info, you talked me into it!
edit: How much is an adjustable panhard bar going to cost me? I have no idea where to look for this and my search isn't working. I'm assuming I'll have to pay someone to put it on for me as well.
edit: How much is an adjustable panhard bar going to cost me? I have no idea where to look for this and my search isn't working. I'm assuming I'll have to pay someone to put it on for me as well.
The adjustable PHB isnto too expensive. check it out.
http://www.ws6project.com/user_stor/...=5c13650a9fb64
It is not hard to put on either. its just a matter of a few bolts coming out and then put back in.
#28
TECH Fanatic
iTrader: (12)
Join Date: Oct 2006
Location: Orlando, FL
Posts: 1,724
Likes: 0
Received 0 Likes
on
0 Posts
Before I forget to tell you....
Make sure you buy some rubberized undercoating from autozone or advance auto parts to spray the wheel well with so all that bare metal doesnt rust.
Make sure you buy some rubberized undercoating from autozone or advance auto parts to spray the wheel well with so all that bare metal doesnt rust.