Roll fenders OR....
Roll fenders OR.... Cut them? What if I used a dremel to simply cut off some of the lip on the inside of the rear fenders? Would this damage anything? I want to space the rear wheels out an inch. I have the stock '02 WS6 17X9 wheels with 285/40 GSD3's. My PHB is adjusted correctly, and I've used a BFH, but there is still rubbing. Plus it looks stupid with the wheels sunk into the fender.
I would also sand the edge to make it smooth, but what do you guys think?
I would also sand the edge to make it smooth, but what do you guys think?
The fenders have spot welds on the lips. I don't know how much those welds make a difference but I would roll the fenders. In the end it will look a lot better. Mine are rolled and you can't even tell unless you run your hand along the lip.
